Hi @Harmon - At this point it has just been around the window (knock on wood). I’ve read your posts and others like it, I’m surprised you haven’t tracked it down yet. Good luck!
I figured out how to tighten the stairs going down to the cabin and figured I'd share with you all.
The 3 bolt heads are underneath the SS threshold strip. Take the 4 screws out of the threshold strip and I also suggest you take the screw out of the plastic trim piece going up the side as...
I just posted this in the 320 Forum but thought I'd post it here as well in the hopes of getting more exposure and hopefully advice.
I had noticed a couple of drips coming from the starboard round ceiling porthole window on my 2005 320 DA. When I pulled the molding around the window I...
Well I finally got around to pulling the molding around the starboard ceiling round window as suggested by @Kbratko so I could have a better look around to see where the drips were coming from. Unfortunately I discovered that this must have been leaking for years as I found a lot of mold and...
I used this stuff:
I used the old Raymarine RAY215 as a template for the outside dimensions as well as the screw hole locations. Then cut out an opening for the new Standard Horizon GX1850GPS using the provided template. Put it all together and went right back in perfectly using the...
Your ER is awesome! You could probably eat off that floor - I’m kind of jealous. I’d be interested in hearing any tips/tricks you have for aligning the belt. I have a lot of belt dust happening too and it’s really bothering me.
On my 2005 320DA there is a round access panel in the compartment under the front port side seat directly over the sensing unit. I would like to think yours is similar.
On a side note, my port gas tank gauge is always all over the place. I had a mechanic check it once and he said the wiring...
We moved our 320DA from North Vancouver down to Point Roberts WA yesterday due to our marina closing down. We are quite happy with the new marina. It was a decent day, a little cool but still ok. Gives me an excuse to post this picture! :cool:
On the 320DA the CO detector is on a separate dedicated circuit with a 1amp fuse. This gain controller is definitely wired in on the circuit for powering the TV - I just can’t get to where they spliced it in. Well I might be able to but that may involve a sawzall or something along those...
Well I pulled apart the Galley TV area trying to find wires and that 12 TV Receptacle shown in the wiring diagram. No luck finding that 12V TV receptacle (I don't think it exists). There is not a whole lot of room to work in and around there either. I've pretty much resigned myself to the...