We launched this past Tuesday.. Yeahhh...17k later
Brand new Bravo 3 drive upper and lower 2.20 ratio shipped up from Texas. My 20 inch pitch 3 blade props up and running c/w merc 3 yr warranty.
I had the mech do fuel pressure test and was within spec he said, also did compression
Test on...
Thank you for all feed back.
I've gone ahead and ordered an OEM Bravo 3 in 2.20 Ratio.
Be about 3 weeks to the shop here.
Mechanic is heading on an Westcoast tuna fishing trip right when eta on drive...lol ..June is shot for an already way to short boating season.
I did install the "celery"...
Im correcting my errors on previous post.
I actually have 20 pitch 3 blade props..my mechanic confirmed the pitch ..my memory is sharp..but darn short..
Here I am siting in the sun on my patio
Having a margarita but
Not on my boat out on the lake..
AGAIN...the outdrive saga has reared its ugly head Again..
Bought a rebuilt upper and lower B3 at 2.20 Ratio, I run 22p 3 blade merc props.
A few summers ago...original drive unit failed and I went...
Here I am siting in the sun on my patio
Having a margarita but
Not on my boat out on the lake..
AGAIN...the outdrive saga has reared its ugly head Again..
Bought a rebuilt upper and lower B3 at 2.20 Ratio, I run 22p 3 blade merc props.
Three summers ago...first unit
Been a while since I've visited site...
We managed a complete season with perfect weather and calm waters, boat ran flawlessley.
Back onto trailer today and now prepping for the long nap. One project I need to do over winter is replace the wiper motor, it has stopped working.
Are there any...
I have to replace my transducer and am wondering
What angle of deadrise the 02 - SD260 hull is at location of the factory through hull ( 10 inches right of centerline ) I recall reading somewhere it is 21 deg. But I can't find that info.
I Need to order correct transducer..
thanks for any help.
Just wondering what the deadrise angle of the SD260 hull is at the point where the transducer thru hull is located.
( 12 inches starboard of centerline ) boat is in the water so I can't get angle. Had a thief steal my gps/ sounder and a new one is Chirp capable but old transducer is an Armir...
Been a while since I updated my B3 outdrive issues.
The saga continues..
I picked up the B3 from the shop June 20th.
Told upper was rebuilt, both upper and lower where flushed and pressure tested and ready to go.."drive it like you stoled it" shop owner says..
I get it installed and it RUNS &...
Just wondering how to safely rig a temporary
Remote start switch on engine in order to bump
Motor over?
So I can do a gimble to engine coupler alighnment.
After removing and taking the reman upper and lower B3 back to the shop I bought it from last week. I got a call from them late friday. Mechanic says the input shaft bearing is worn and input shaft seal Is bad. This, he says is causing the rattle from out drive when changing drive angles, trim...
I have been speaking with the company who rebuilt the drive, under the warranty, they offered to replace the u joints with new greasable units, meaning I will be pulling drive and transporting it to thier shop.. When drive is off, I will roll the engine over by hand to see if alignment shaft...