Recent content by vrcrdavi

I have a clean 2004 300DA that I have for sale right now. Let me know if you are interested and I will send you additional info.

Just went down to the boat to sanitize the fresh water system. The pump continuously ran so I started looking for a leak. I found that the water was coming from beneath the galley faucet. Anyone know the easiest way to gain access to that faucet?:huh: I have a 2004 Sea Ray 300 Sundancer.

My light has quit working somewhat. I can move it left and right, but not up and down. The spot and flood light is not working. Can someone give me any ideas about troubleshooting these issues as a new one is $1000? :huh: I have a 2004 Sea Ray 300 Sundancer with a SPOTLIGHT, 5" SS GUEST.

All of the hoses and fittings are fine.

My water manifold developed a leak. After further investigation I found one of the 1/2" male fittings on the manifold is cracked. So I'm going to have to replace it. The manifold has 8 cold and 4 hot leads. Does anyone know where I can get one???:huh:

I have twin 5.0L mercruiser/Bravo 3 on my 2004 300 Sundancer. Yesterday I went out and the boat would not plain. The engines would not go above 3000 RPMs even if I pushed the throttles fully forward. I have no alarms from the Mercury Smartcraft system and all gauges are normal. Any insight that...

The trim on my swim platform has come loose and today almost fell off. Has anyone ever had this problem and if so, what did you use to keep it on :huh:.

Does anyone know the make and model for the refrigerator on a 2004 300 Sundancer. The interior is a wedge shape and small and sets under/near the sink in the cockpit.:huh: Thanks

Does anyone know if there are holes in the bilge stringers to allow water to drain down to the bilge pumps? I have a 2004 Sea Ray 300 Sundancer. :huh:

I still have not figured this problem out. The indicator light for the anchor does not light up when pressed. I have checked every fuse and all are good by swapping most out with new ones. I started troubleshooting from the batteries forward. The solenoid in the engine compartment has power...

You must be talking about the 100 Amp breaker. Do you remember how to reset it?. It is a strange looking breaker and I'm not sure where the reset is. Bill

Where is the breaker located you are referring to?

I have a 2004 Sea Ray 300 Sundancer and the windlass just quit working. I get no light at the helm switch and no power at the windlass. I have checked all of the breakers and fuses that I can find. I have switched known good 5 amp fuses with the the ones in question without any positive results...

I have a 2004 300DA with T5.0L-B3s. The issue I;m have is that when I first start the engines the Smartcraft digital and gauge shows the temp at between 123-145. This has never happened since I've owned the boat (over 2 years):huh:. Any ideas on this would be greatly appreciated. Thanks

Have a 2004 300DA with twin 5.0L-B3s. My issue is that when I start the engine after it cooled for days and the temp shows 125-143:huh:. It has never done this before in the past two years since I've owned it. Any help or ideas would be greatly appreciated. Thanks