Recent content by tomk

Hello I am Installing Ray Marine Autopilot on My 360 sundancer the Problem is the Hydraulic pump has three ports and the Steering system only has two lines and it tells you to take the return line to the reservoir well I have no reservoir tank so i am not sure how to plumb the pump thank you in...

Point Of interest 8.1 Horizon do have Metric I Learned the hard way best to be prepared I Was not thank god friends with metric tool save my but

I Purchased Them Online I forgot the manufactures name I Just did a Google search for them sorry I didn't have web site for you

I have 2002 360 dancer I have had the same problem replaced the converter in both the freezer and fridge it is mounted behind the units on piece of plywood the relay in the converters go bad there is one for each unit remove the screws from the molding and units will come out one side of the...

Thanks Creekwood I Am Going to give that a Try as soon as work cooperates an gives me some time Off I will keep you posted tomk

Hello was wondering I if I can connect the Pathfinder smart heading System with the Gyro Plus 2 for the electronic Compass to the Classic C-80 Chart Plotter ,Radar thru the NMEA 183 or Sea Talk is it Compatible ? Thanks in Advance Tom

Hello was wondering I if I can connect the Pathfinder smart heading System with the Gyro Plus 2 for the electronic Compass to the Classic C-80 Chart Plotter ,Radar thru the NMEA 183 or Sea Talk is it Compatible ? Thanks in Advance Tom

Yep I Have That T Shirt Port side Is inside the Cabinet in the over the sink in the head and Starboard is in the cabinet in the aft behind the power panel hope this helps

Were does that IAC muffler live on the motor I have not seen it? on mine yet

I also have 8.1s and about five degrees difference 163 and 168 you have to remember that the gauges are not performance gauges

I would check the power supplies behind the fridge and freezer there is A relay that flips one way or the other 120 or 12 volts I had to replace them both power supplies last year same kind of problems you can find them on line for about 120 bucks when I installed my new power...

hhettre

Along the lines of the chop saw I used a four and A half inch grinder with one of those speed cut wheels (thin grinding wheels) works well but A little smokey

WOW I will never complain again when we pull my boat with A crane and it's 15 foot in the air !!

No i didn't shut down the other motor when i tried to restart the starboard thats good to know that both motors have to shut down before the smart craft system resets I am going to try the contact cleaner on the connectors and hopefully that will take care of the problem I hate these...