Recent content by TN370

Sorry I thought the picture would be clearer to see the RPM. I was running 2250 to get 23 mph. Fuel and water tanks full with 8 passengers onboard. Props are 23x26 with a #7 cup. 2001 with Cummins 6CTAs. Yes hardtop and hydraulic platform.

This is from today/right now lol.

Ok so got no 120 in the cockpit or outlet in the engine room. All 3 GFI are not tripped. Any ideas?

Anyone happen to have a wiring diagram for the mast light? I don’t think mine has been right since I’ve owned it. Thought it was bulbs. Then replaced the whole top light. Still won’t light up both from and back with “anchor” on. I opened up the access below and found a spaghetti of wire. Help...

Doing some cleaning in the engine room and I filled up the area under the port motor with water before I realized that they don’t drain out. Is that normal?!?! Probably has good reason. But very annoying for a clean freak. Anyone drilled holes or something to drain?

Hope everyone is enjoying the summer. Who’s got the best replacement for this mast light? Mine is bent and the salt water has sent it to bed.

Is one of these really that much better than the other? Mine are getting loud and time to replace. Is the expensive one really any quieter?

Anyone attempted to try to level the surface between the area for the MFD and the area below it where I have a VHF? I’m upgrading to new Garmin electronics. I’d love to squeeze in two new 12” MFD displays. Thought about a piece of star board to raise the area up. And then a new wood grain panel...

Anyone found a better solutions to putting the chocks on and off the swim platform? There’s a thread on here where a member was modifying the standard chocks. Search Quick Release Chocks. But he’s not making them anymore. And those retro fit pop-up chocks are outrageously expensive. And not sure...

Would still love to get a set of these made! Happy to pay a premium if someone’s willing to tackle it.

My starboard alternator is overcharging. Pegging out at 16v and killing my electronics. Guessing it’s a bad regulator. Can I disconnect it and still run the motor?

I Missed the chance recently to buy a used set of these. Anyone still making them? Would love to have a set…

I saw those too and was curious. SO much more expensive and higher amp draw. What made you get those? Do you think they’re quieter than the online style?

Any advice on engine room blowers? One of mine is starting to squeal. Going to change both. Currently have the shurflo yellow tail. They seem to move a lot of air but seem loader than they should be IMO. Curious if anyone has found something they feel is quiet and still moves the air. I read...

On that note, I saved the couch and will give it to anyone that wants to come get it. I’ve had it for sale for a few weeks and no bites. It’s in really good shape. Actuator works. So if someone on here is willing to come to TN to get it, it’s all yours!