Recent content by thbouro

Thank you Amajamar, wish I had this info before my order, I ordered individually each part from the web and I expect them to be delivered soon! Anyway, thanks a lot!

Hello Captains, I have to replace the Electric Fuel Pump (p/n 861156A1) and Fuel Cooler (p/n 861267A1 or 8M0125847), 350 MAG MPI MIE (2001), the Cooler is in bad condition and the Pump stopped working. Is there any kit in the market containing all the components (pump, cooler, fittings...

Thanks a lot! I thought there was a specific type for the 310 SD! I googled it with the p/n from the Parts Manual but couldn’t find anything!

Thanks! Any idea where to purchase a sending unit, just in case?

My Starboard fuel tank indicator is inoperative (needle stuck to the left, beyond E-Emplty). Any advice what to check or to do before replacing the fuel tank level meter (sending unit)? Thanks in advance!

Negative, I used the same wiring, it’s working with no problem!

Could you please ask the 310SD (V-Drives) owner and post some more details about the four blade props upgrade? (prop size, performance comparison, consumption difference, etc). Thanks

bobeast, fyi, yesterday I visited my boat and did what you adviced me; each engine run for about 30 min without any RPM fluctuation, so probably it was the umbilical cord! On the contrary, I noticed again Temp fluctuations, the same as previously, with a trend of lower temp reading, which I...

Could you please post the results?

Thank you for your fruitful info! Hope it's not the wiring issue! Is there any specific way to check the sensors, other than replacing each sensor with a new one?

Thanks for the reply Stee6043, this is a very good point, unfortunately I didn't check it! I suppose that, if I had depressed the bypass/preheat button and the engine refires, it was an indication of faulty safety switch (Oil pres, exhaust temp, water temp)! Is that right? What I noticed is...

Engine shuts down after about 12 min of steady operation under no load. No apparent rpm increase at the moment of the shut down. Any thoughts?

Thanks Lazy Daze, wilco!

Thanks bobeast, I will try it as soon as I visit my boat!

I didn't work on that (unfortunately no time available!); actually, the boat is dry docked for the whole summer season, far away from my location, and, whenever I can, I operate the engines for about half an hour (engine flush procedure), following my mechanic's advice. Last time I visited her...