Recent content by sweet revenge

i had the same issue with mine. turnout to be the fuel line was collapsing inside after running. replaced fuel line issue reolved.

Hi . My port4 in 1 gauge died. I need to replace it p/n 1040905 . No seems to have it. All that I find are smart craft , is there a way to connect the smart craft to the nine smart craft gauge????

hi , my gimbal on port engine is leaking. its an alpha1 gen 2 . how do I know were is beat to order and if its a gen 2 does the year matter???? would greatly appreciate your help. thanks mike

Hi my 02 sundancer has a kolher 5k model 5e generator. Lately when I shut it off after a few hours of use. It will turn on by itself??? Even if I shut of the gene and shoreline switch.. Has anyone had this issue????

Hi, my trim connector block went bad, my question is when I removed the cover. Instead of a zinc plate it has a plastic cover with a sensor on it. 2 wires run thru the hose connector into the gimbal. Can I cut the wires and eliminate that sensor? And or what is that sensor for?:huh:

Thanks I will give them a call

No, I mean the Bimini tops on the arch

H, I need to replace my sunshades on my 280 . Does any one know where to get the best price and the right fit ? thanks

I would definitely get o.e. Mercruiser parts . Barr manifolds cost me a new engine

It's been 1 year since I repaired my holding tank and it is still holding perfectly. Again I drilled out the bottom nuts, where the leak was coming from with a 1 inch hole cutter ,then I installed a 1 inch seacock plug ( twist on) applied marine tech and inserted them in the 1 inch holes I...

I found the IAC motor. napa has it part # 3-1813 brand nap proformer, incase anyone else has this issue

I took it out but the motor is jammed, wont move

Does anyone know the correct part number for the iac motr on 2002 mercruiser 4.3 efi w/tbi. Tried 3 all are different. please advise thanks

hi. need help with smartcraft gauges. this is on a 2006 300 sundancer.I cant get the depth finder to work on my gauges. it use to show on the starboard gauge. I reset the three gauges and it doesn't work any more , it shows them trim but not the depth finder. when I reset the gauges . I set the...

hi. need help with my smart craft gauges.I use to be able to see my depth on the starboard gauge display.nd know it doesn't work. I pressed the reset on all three gauges and it disappeared. when they reset. it asked . which engine port or starboard I set the starboard first. it asked for...