Recent content by stevesavage

  1. S

    Mid-90's 270 Sundancer Thread

    I went back and checked and do did not have any breakers on the port side. It appears my wiring goes from the DC distribution on the port side across the forward part of the the engine room and up the starboard side by the helm seat to the control station. I am not able to find the point where...
  2. S

    Mid-90's 270 Sundancer Thread

    Hoping someone might have some suggestions. I am having an electrical problem. I have power at the battery and the DC distribution. I do not have DC power at the helm. I still have power to start the boat. I do not see any breakers tripped. I do not think that power is getting to the...
  3. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    My upholstery guy had suggested just going back with Velcro. If I did not already have the headliner pulled at that point, I would have gone that way. Good luck with yours
  4. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    Enclosed are pictures of the screw locations after I pulled the cushion up. I had to pull the mirror piece down which then allows you to drop part of the ceiling panel. There were some screws still holding the other side of the ceiling panel in place. I ended up backing them out through the...
  5. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    The upholstery guy though that the board might be fine as is, but we are going to take a closer look once he gets the cushion apart. If not too bad I may just recover it and attach with Velcro. If it is shot then I will look at some of the alternatives you mention. I notice that I do have one...
  6. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    I did find that the bottom of the lounge seat is secured with about 5 screws. They gave way when I pulled up on the seat. I think I may use velcro when I reinstall the seat once the shop has replaced the vinyl. I will look around a bit more when I take these out to see how I could have...
  7. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    I will to verify what I can see from underneath tomorrow. It does appear that the coaming portion of the custion is attached with on bolt that I can see from the part of the interior I have removed. I had pulled up on the bottom cushion and it did not budge with a fair amount of force. But I...
  8. S

    Removal of Port Lounge Seat Custions 1996 Sundancer

    I am working on removing the port lounge seat custion on my 1996 sundancer. I have been able to pull down the interior side piece with the mirror in the mid-cabin, but I have not been able to determine how to pull down the celing piece to allow access to the seat above. I removed the screws that...
Back
Top