Recent content by someguy289

  1. S

    A/C unit not pumping water (new pump)

    Is there anything on the computer board that controls heat? Heater turns on, i hear the click switching to heat mode as normal. Air blows out, but no heat. I'm thinking of ordering a new board from the link above. But only 2 weeks left in season
  2. S

    A/C unit not pumping water (new pump)

    Update *** I was able to get the ac/heat working correctly with water shooting out the side of the boat. - I had no power at the pump and traced the wire back to the computer board. -Power In,had 112v on L1 and n/L2 (correct) -Power to the pump I had between 35 to 50 volts ( N/L2 and pump)...
  3. S

    A/C unit not pumping water (new pump)

    Sorry, my question seemed confusing. I got the boat up on plain, and water shoots out of the trough hall fitting and doesn't appear to be blocked. I believe the water pump isn't even turning on, even though the air is pumping in the cabin.
  4. S

    A/C unit not pumping water (new pump)

    Hey guy, hopefully you can help with my a/c and heat not pumping water but blowing air correctly. The a/c was pumping water correctly, we had the cabin set at 68 degrees and one night was a little colder, so we set the temp to 70 degrees before bed. We had the system on Auto and woke up with...
  5. S

    Smart craft issue

    Hello all.. Hopefully someone can help as we are stuck at a resort and cant make it home. Long story short.. after the power going out a few times in a thunder storm we aren't able to start our starbord engine.. Please see that attched photo... when we turn on the keys.. port starts as...
  6. S

    Bow & Swim Platform Speakers

    Does anyone know where the wire from this switch goes... Does it go into the compartment that houses the amps.. Is it wired like an amp turn on lead that turns off the amps. Colour? I would like to use this switch for something else.. since I have run all new speaker wires from new amps
  7. S

    AC Inverter

    I have a battery inverter and was having a similar problem of only working when connected to shore power or genny. When I was underway (engine power) or not plugged in the lights on the GFI outlet where not lit.. I ended up finding it was connected to my Accessory #1 breaker on my fuse panel...
  8. S

    Acc1 Switch

    I might try that.. I should add that ACC2 is wired to the factory white underwater lights and I added Lumitec seablaze X in blue and wanted to add them to ACC1.. even though I don't really use the white ones.. I could track down their wires
  9. S

    Acc1 Switch

    On my 330, dash switch ACC1 was unused and ACC2 was wired to the underwater lights. When I wired ACC1, I found that it was wired to a red/violet #14 wire designated #500 (under the dash). Just inches out of the electrical interface module under the dash(the box with the push breakers) this wire...
  10. S

    New 350 Sundancer

    Sorry to bring back an old post, Trying to get my underwater lights wired to ACC1 switch. I was able to locate the plug and wires listed above. Brown # 349 and black #348. I tried hooking up the red from the underwater lights to brown and black to black... and then hit the switch and nothing...
Back
Top