Recent content by skillz48047

  1. skillz48047

    Bennet trim tab ?

    I have a 1987 sea ray 390 EC It has the standard black double rocker switch to control the tabs, along with the bennet auto tab controller (i will attach pics of both) My question is im in the process of remodeling the dashboard/helm area and i want to replace the trim tab double rocker switch...
  2. skillz48047

    390 EC additonal trim tabs

    Great! Thanks for the response i was thinkin the same thing, easier to buy the parts and do it myself
  3. skillz48047

    390 EC additonal trim tabs

    I have a 1987 390 ec and want to get everyones opinion on a couple different options ive seen on this site over the years. i have seen some guys go the fixed tab route and ive seen some guys add 2 additonal 12x12 trim tabs to the middle of the boat. i would like to do one of the two but would...
  4. skillz48047

    80's era marine air systems issues

    I checked all the connections, they all look good, loosened and re tightned them to be safe but no luck, same symptoms, red light is on during start and run and no activity from the unit itself
  5. skillz48047

    80's era marine air systems issues

    When you say red 8 pin connector, is that on the back of the three knob control panel or is it on top of the unit itself?
  6. skillz48047

    80's era marine air systems issues

    There is nothing happening with that unit, the orange light on the panel is lit up on start mode and run mode but the unit itself isnt making a single noise not even trying to turn on. No fan no compressor nothing! but the aft unit is working normally and my water flow through the two thru hulls...
  7. skillz48047

    80's era marine air systems issues

    I have a 1987 390 EC. Im having a issue with the forward air conditioning system. Last night while i was sleeping it basically stopped working. The breaker never tripped on the main panel but the fan is not blowing, the compressor is not running and the weird part that i hope will help...
  8. skillz48047

    Official 390 E.C. Thread

    If its not letting you through i would just make a new hole
  9. skillz48047

    Official 390 E.C. Thread

    I just snaked the wire through the silicone and it went fairly easy if u try ripping some of the silicone around the outside of the hole u will see the best spot to try to go through then just reseal with silicone if this doesnt work makng a new hole shouldnt be a problem just reseal it and u...
  10. skillz48047

    Official 390 E.C. Thread

    No signal loss via speaker wire i used 10ga wire though....... little bit of a PITA to snake the arch but not a big deal bus bars do NOT have enough power for a amp definitley need to run wires to the batteries silicone comes out easy enough just replace it with GE silicone I from home depot easy!
  11. skillz48047

    1989 390 ec

    what gel coat color?
  12. skillz48047

    Official 390 E.C. Thread

    I have all four of my amps mounted in the cabinetry above and behind the couch in the salon. I have bazooka tubbies for my radar arch speakers, they each have a front and rear facing speakers so it projects the sound to the bow and to the swim platform. under the drivers seat is a clever idea...
  13. skillz48047

    1987 268 Sundancer Dash Over Haul

    Looks great!!
  14. skillz48047

    390 Express Cruiser, 1991

    If u need lens covers i have a few extras from old fixtures that i replaced Get me a pic and i would gladly give them to u
  15. skillz48047

    Anyone have a wifi repeater on their boat?

    I have a rouge wifi antenna i love it!!
Back
Top