Recent content by seattlesearay

BT Doctur and Frank ---- That's clarified my mind! Thanks a lot!!! Be a newbie, nothing may not too earlier to me-:)

I have a 16 ft 89 SeaRay open bow. There is no anchor system or component to put a anchor. I understand I need to buy an anchor, rope, etc. My question is ho can I put the anchor on the boat? No electric need and just like something sample. What's else I need to buy in order to put an anchor...

I have Mercury 89 100 HP two stroke outboard motor on a 16 ft Searay boat. Does the motor need to be winterized during the winter? Or anything I need to do during the winter? Thanks!

I add gas stabilizer and checked the filter. However I can't motor to start the engine now. I turn the key, I only heard one click. What should I check? This happen before, if I wait for a while to try few more times, then the motor will run and start the engine. But now, there is nothing...

I learn a lot. although this is a just a start, I can start with basic and free items to check into. Many thanks!

You are right on! English is not my first language. Knowing a little about boat challenges me even more of this conversation. One thing I am going to do ---- drain the gas from the tank. because the problem right start after I add gas which is different then I used before. Thanks of your...

It looks like coil could do the trick. Thanks a lot! Other question, recently, when starting the engine, sometime I only heard click but nothing happens, then wait a while, I can hear the motor runs and engine start. What could be the problem? Does this could be related with Coil as well?

I heard some people said I may need to rebuild carburetor. I have no ideal about it. What's cost range to rebuild carburetor. BTW, I did checked the filter. It is OK. Thanks!

The 4 speakers are new. Fuel I think is OK. I just add the fuel one week ago. What is plug? How can check it. Thanks a lot of your quickly replay!

I have 1989 Sea Ray open bow and Johnson 100hp on board motor. The engine is hard to start but works before. Now I have to push the gas hard to keep it run. Otherwise, it will stop. What should I do? Any recommendation for a repair shop or repair man in Seattle Area? Thanks!