Thanks. Iv'e used Brillo pads before to clean car windshields and it works pretty good. Figured I'd give it a shot but I wasn't sure do I did a very small corner on the side in case it didn't work out. It doesn't look any different. I'll try the vinegar and water idea. tonight. Thanks for the tip!
Good day all. I recently purchased a used 2012 240SD. Over all the boat is very clean but the windshield has heavy water spots on it, so heavy in fact I have to look over the windshield to see. I have tried a Brillo pad in a small area on the side with little effect. Does anyone have any advice...
I had one screw and those 2 plastic knobs. A couple long flathead screwdrivers did the trick then a little elbow grease to lift the seat bottom out. It was wedged in there pretty good.
Thank you for the reply. Got home tonight and decided to knuckle down and figure it out. What a PITA! The seat bottoms had to come off but they were not vercroed, they were held in by opposing pressure clips ( best way I can describe them). Then the bolsters were basically popped into sockets in...
Good day all. I just purchased a 2012 240SD. The upholstery is 95% nice but the staples have rusted out of the flip up bolsters in helm and front passenger seat. The material is fine and I'm confident in my ability to repair, however I can't figure out how to remove the bolsters from the seats...