Recent content by rmm

Irie308 where did you get the 90 deg for the boost sensor? Also does it have to be calibrated?

The little spring (similar to below but has hooks on end) that pushes the tab out broke and cant find the part. Spoke to Southco and FP marine and basically have to buy a $115 handle set to get $0.50 spring. Anyone have any ideas? I've looked far and wide.

https://www.pacergroup.net/products/panels/switch-covers/

I installed a Spa dual EGT last year and very happy with it. Dual digital readout with ability to label, change colors, alarm, etc. Motors are Cat 3208s and had temp readings in 850-880 range which is borderline high. Found had leaking exhaust elbows and worn turbos. Replaced both and brought...

Talked to the and supposed to be available April/May.

Take a look at these new dometics. http://www.dometic.com/QBankFiles3/EPiServer/Dometic/US/Specification-Sheets/Marine/Refrigeration/Built-In-Refrigerators/3467-CRX-Refrigerators-specsheet-Web_33484.pdf

Does anyone use one under a Bimini or do they put out too much heat above and would damage it?

See if you can find one of the haulers for Tiara who's heading back empty. Tiaras in Michigan and sure their trucking boats to Fla.

Why don't you have Cat dealer (not a certified 3rd party tech) change the oil, then put 10 hours on the boat and take another sample.

Bart - lights look great. Hard to tell from pic but is there a lot of glare from the ones mounted down low? Are they too bright to look at?

22# Delta plow with 15-20 chain is more than sufficient and already upsizing one. Chain is key to how well an anchor will hold. A 14# with sufficient chain would be fine in most situations. The 35# is overkill particularly if you dont have a windlass.