They are mounted up by the valves in the engine compartment, my 330 is the same way. Found the valves on Summit Racing which is right by my house should I ever need them, $35.99
Anyone ever tighten one of those up? Is there a packing nut on there like a water valve or are they replace only? Can't wait to try and locate one of those.
Bought a new to us 1998 400 Sundancer last weekend and getting ready to bring it home to Huron OH, question is about the tank valve(starboard/port) selector premade hoses. I think one may be leaking so the previous owner may have the selectors set to prevent the leak? Not sure and won't be...
I'm just getting ready to install a EV-150 Autopilot on my '96 330 DA. Will do a quick story like I did when I changed over to hydraulic steering from cable (first step toward autopilot). I see the toughest part is getting a Seatalk spur cable down to the EV sensor, would like to mount it in...
Just replaced both lights this weekend with a pair of LED ones I got off Ebay
Companionway LED lights that I bought on ebay for under $13 for both.
Also have the two old ones if anyone is looking for a pair of original ones with wedge bulbs.
Are these companion way lights 120v or 12v? I can't get to my boat due to storage and would like to replace these lights but unsure which voltage they are?
Thanks!!
I converted my 330 to hydraulic after trying to lube the cable that couldn't be lubricated, no way to get to the inner slide at the end to grease it. I did an entire write up on how I converted mine from cable to hydraulic, it can be found on here.
Here is the link:
Cable to Hydraulic Steering...
NO GREASE in there, that is Hydraulic steering, there is hydraulic fluid in there. I would disconnect at rudder tie bar and see if it is steering that is stiff or rudders are stiff moving left and right. There are no grease points on that steering that I know of.
On mine, the stereo head unit (Fusion RA770) is controlled by the breaker in the power panel but my power amps have their own dedicated 40 amp breaker which is fed by #6 wire due to the power draw of the amplifiers (one 4 ch and one mono block for subs). I mounted my 40 amp breaker closest to...
This may help if you don't already have it
https://www.kohlerpower.com/onlinecatalog/pdf/tp6772.pdf
I was unable to locate that specific code but may want to look through it to see if it helps you? Good luck
I got the truck sizes from Ben at Flounder Pounder but he was out of the track so he suggested I contact Boat Outfitters which I did and was able to get everything needed. I will say, when we removed the old track on top it was shimmed with cut tywrap scraps and lots of silicon due to the...
Here was my order for my 96, hope it helps. I was able to get the truck sizes from Ben at FPMarine but they were out of the track so he directed me to Boat Outfitters which worked out perfectly.