Recent content by rdevans

first let me say this is a very elegant solution. Two issues.. 1) the symbol for the diode is a Zener diode. not a big deal. 2) since the data sheet says you can connect the inputs to either + or -, that would lead you to believe the input circuit is a comparator. Thus just a small amount of...

I am also interested in the details of how much you had to disassemble to get it out of there.

Anyone else have some experience with this??

I have a 1999 340 Sundancer with V-Drives. I am interested in removing the Generator to do a rebuild/refurbish this off season. Can anyone tell me specifically what needs to be removed to make room so the generator can be lifted out?

I am interested too. Please let me know when they are available.

I would be interested.

Do you have a recommendation??

I had the same problem. The AC unit under the V-Berth was not communicating with the wall control unit. The AC will stay in the last mode before communications is lost. What you need to do is remove the panel from the wall (4 screws) and check the connections on the cable between the panel and...

I can't believe that there isn't a replacement available other than Taylor Made. Looks like a market.

Does anyone know of a good place to find a replacement for the flip up windshield vent on a 1999 era 340 DA? Is there a place to by the gasket material to make one? Part numbers please. Thanks

I would be interested in that replacement also. Thanks

Book 'Em, I have the exact same boat as you. You don't really need all that stuff to winterize: - Pop off the strainer top and get ready to pour "the pink stuff" in - Shut the seacock so the pink stuff doesn't run out the Seacock - Start the engine and start pouring the pink stuff in until it...

I bet the second cord is for a refrig full of beer!!

Can you buy the bulbs that go in the gauges? If so, where?

What dimmer did you use, and what LED's for the switch back light? Thanks, Bob