Separate names with a comma.
Hi All. We have outgrown our boat so we have listed our 2005 340DA on Boat trader. If you know of anyone looking for an extremely clean Sundancer,...
Switching to LED bulbs in the cabin. Can someone please tell me which bulbs are needed for the cabin ceiling lighting? I did a search on the...
I figure that the previous owner may have installed it so it could be kept on a lift. just another place for marine growth to hide out.
[ATTACH] [ATTACH] [ATTACH] We have a 2005 340DA. does anyone have a Jabsco check valve installed on their A/C water line intake between the...
yes, I had this happen to me and it pulled one of the mounts away from the hatch lid. My problem was the switch pad going bad so I Suspect, yours...
Hi All. We have a 2005 340DA. We want to replace our stock Clarion receiver with a Fusion unit, replace cockpit speakers and add a sub. Has...
Thanks Kevin. Are you happy with the Raymarine? I'm not sold on either Garmin or Raymarine, I just have lots of friends here in South Florida...
New Garmin GPS Chartplotter question for my 2005 340DA It's time to retire my Raymarine E80. The unit still works along with the radar, it's just...
I like the new system. Their instructions were spot on however, I recommend having some help when it comes time to run the new wire bundle from...
I just replaced my entire system with the FP marine EIM panels. I have entire system for sale. May list on EBAY also. Will post pics in a new...
I will be selling my entire system once I install the new system. Hopefully be early next week.
I was able to get mine repaired for $20 at a local fabrication shop here in Boca. installing it today. thanks
Well, it appears that both my switch pads work fine so my problem is with the eim box itself. I bit the bullet and ordered the retrofit kit from...
I’m searching for the actuator mounts that are attached to the underside of the engine hatch. The ones that the rams mount to for raising and...
Tried some of that already. not sure how those actuators pull so hard. This steel is extremely hard. I can move it with a 3lb sledge.
