Mark,
see post #5096, also, nuts for bolts for table support can be accessed in cubby shelf in port stateroom wall. I know someone on this thread was looking for floor take outs in the last year!
Steve
I believe you find reverse threads from one to the other, also vacuflush pump will have 4 duckbills, discharge pump will have 2.
Vacuflush pump black? Discharge pump white?
Bruce, Like the Highfield a lot, 6 years, 500 hours, Michigan, Florida, Bahamas, no issues. Did add a transom mounted inline fuel separated after getting bad fuel once. At least 8 marina mates here in Michigan have bought them since we did, no complaints. I would buy again. I have no knowledge...
Turn it back on, push throttles forward will top out at the current setting, adjust from there with the rpm+/- switch, I believe it will change in 20 rpm increments & will stay wherever you set it.
Cheers!
Ha! Don’t feel bad, had the same thing happen to me a couple years ago, called a Cummins service center a couple days later while making a service appointment with the lady who answered the phone, she picked up on the problem! I had never used the cruise control before but… use it all the time...
Had our sofa out a couple years ago, not a bad project. Removed folding bed & back cushions then screws attaching base unit to back cushion frame and salon floor. Can un screw & remove end arm rest at this point also, will need them off at some point to re upholster, will also need to remove...
Mark, Yes we replaced the flooring in those areas. The dinette portion comes out as one pc, may have some silicone holding it in place & also bolts & screws at base of table leg. Dinette step silicone only. Galley is all on one pc of plywood with a few screws coming up from holds underneath, if...