hello all, just looking for some advice installing an alternator. I have it all wired up but i'm having a prob getting it to fit into the bracket. it is the right alternator but because of the limited space in the compartment i'm having quite the hassel forcing it into place. thx for any and all...
im in Wyandotte but I usually trailer but I need to have it repaired and don't have time so ive never had to do the haul out and storage. was hoping to see if anyone knew some of the rates. but I do know keans is great but I imagine they are expensive as I would think Gregory would be as well
I ran the motor and revved it up 2 to 3 times until it stopped sprayin water out the exhaust the shut it off. I then removed the hose from the water strainer and put it in a bucket with two gallons of antifreeze-50 or maybe higher, cant remember, and ran the engine until it sucked it all up and...
buy the way my uncle used to have a similar sized carver with a single 350 and it had a flybridge. took it to Put-In-Bay in lake erie on a trip and it performed well- didn't seem underpowered at all and not too much roll either.
I got a 10 ft beam so its a liitle wide but it does roll a little bit but it depends on how rough the water is but overall I'm happy with it. on the Detroit river going through downtown can be messy, its the narrowest part of the river and both sides are seawalls so any wake just bounces back...
I have an 83 270 with a single 330.....I like it, it does labor to plane but once up it cruises pretty good and goes. ive got it to about 35 36 mph wot but usually cruise nicely in the mid 20's
at first I thought the tank cracked but then I was like since it wasn't full there is room for expansion so it couldn't have cracked. well ill have to check the line and disinfect/clean the mess. thanks for the feedback.
hey all, had an inch or two of smelly "water" in the aft cabin floor. pumped it out but pretty either the tank it cracked or hoping its just the hose. wondering if anyone has dealt with this before and how would I begin to tackle this prob? I have an 83 27 foot sundancer, any advice will be...
Hello, yesterday I noticed a small crack about maybe an inch long on the outdrive just above the lower unit. I then removed the plug on the bottom and about 2 to 4 drops of water came out. that is not a good sign but was wondering if I could possibly get away with welding the crack?
Not to totally hijack this but today I was looking over my boat to go over what work im going to do to get it ready for launch in a month or so and I noticed a small crack on the outdrive. I decided to pull the plug on the bottom of the drive and a little bit of water dripped out. Just wondering...
Hello, just wondering if anyone has ever replaced a gimbal bearing on a trs outdrive. I know it is a little different because the bearing is in the trans tailstock. Need to get it done in a couple weeks and was looking for any tips. I have an 83 srv270 with a single 454, trs outdrive and a...