I've done more testing.
When I use the multimeter between connector and ECU and ground I get a value of 1,06 volt on each side (I wrote 3,78 before but that was incorrect)
When I connect the sensors and do the same test the right sensor still shows 1,06 volt but the left says 0,22???
Does...
I tested both sensors with a multimeter and gets exactly 103 ohm at both sides.
I also tested the wireconnectings on each side by putting one side of the multimeter in the wire and the other side to ground.
I got exactly 3,78 volt on each side with motor turned off and just using the...
Something wrong with the URL.
tries it again:
http://www.hansenkatalogen.se/sv-SE/HansenMarine/Startsida.aspx#/marine/code/dd1/y/71/1/31251/1713125118897/["17230"]
The sensors I bought is this:
http://www.hansenkatalogen.se/sv-SE/HansenMarine/Startsida.aspx#/marine/code/dd1/y/71/1/31251/1713125118897/["17230"]
But they have'nt worked at all after changeing
I just unscreewed the old ones and replaced them with those.
No cleaning or so.
Is there a way...
Hi,
I have a Sea ray 270 Sundancer with a Mercruiser 7,4 MPI (MEFI-3) modelyear: 2000
I just scanned my ECM and found this error code. I cleared the code and ran the boat and the alarm goes off again.
My engine alarm goes off between a few seconds and a few minutes of going on plane above...