Recent content by ppwhite

Has 3126 with under 800 hours.

$135,000 it has 790 current on it. if you need more info my email is ppwhite2005@gmail.com

2000 410 Sea Ray Express • Twin 3126 Caterpillars Diesels • bow thruster • Replaced complete water pumps and did all the Zincs with all new Cat coolant in 2018. Hours were 785. All oils and filters have been done with Caterpillar only parts. I wash the bilge weekly and clean engines. •...

Anyone had any gauge problems. I have cats In my boat 410 Express,one temp gauge reads 185 and the other reads 200. If I go below in the engine compartment they both seem to read to 185. Water pumps are new coolant is all new and exchangers were all pulled and cleaned. Don’t know if I have a...

Thank you for all the help. No Alarms what so ever and always had Cat oil and filters in it. Boat only has 690 hours on it. Runs great. Just nice to hear feedback.

I have a two part question,I apologize if one of the questions is not in the correct section. 1) I just got a 2000 410 Express with 3126 Cats. If I am out running the boat and come back to the marina, and pull back on the throttles to a No Wake zone I notice the oil pressure drops to 20 psi...

Yes that is the boat. Made a last minute deal.

I have been boating most of my life. I sold my 400 dancer with 7.4 gas motors and bought a 410 Express with 3126 Caterpillars. I am very excited! The boat has all the paper work with it and Cat performed a 250 hour service and 500 hour service.The boat currently has 725 hours on it. The boat has...

On my 40 foot dancer with 7.4 380 hp I am in the processof changing exhaust manifolds and risers. My current setup has coolant in the manifoldsand the 6 inch extensions. The other sea rays on my dock that have the same motorhave raw water running through theirs. All these boat are in fresh water...

I have a 1999 40' dancancer with two new 7.4 horzion engines. I am using 25-40 mercruiser fully sythenic oil . If I run the the boat hard when I come off plane and go under 1000 rpms by oil pressure drops to 20 psi until the oil cools off then it goes back to 40 psi. The boat runs great the...

What is that procedure? ?

I have 1999 400 sundancer with a 7.2 Westerbeke gen that won’tstart from the remote panel all the time. Sometimes you get lucky and itstarts. I checked it out yesterday and I believe the black box mounted in the engineroom next to the gen called monoplex gen-set 4 controller is bad. This...

What is the trick to removing bottom paint ? Sanding ,soda blasting,paint stripper. I sanded on my old boat and it was not fun. If you are sanding what kind of sander are you using.

Crosser i am having the same problem with 7.2 westerBeke can I separate it in boat or did you have to pull the whole gen out the boat. Could please let me know what you find with yours

I have two questions . First how come I cant open links like that is posted above about the duck bills. It gives me Error messgae stating I dont have access. How do I get access this stuff. Next question is I replace the the duck bills and I still have a leak because the vaccuum pump runs...