Recent content by Pierpressure1

  1. Pierpressure1

    Bilge access on 2003 400 sedan bridge

    Did you get access?
  2. Pierpressure1

    40 sedan bridge forum

    Figured it out today. The check valve on the forward emergency pump was bad. Water entered through the discharge through hull fitting past the Whale Check Valve. Going to replace them all.
  3. Pierpressure1

    40 sedan bridge forum

    We are cruising the Chesapeake this week and for the first time water is getting into the forward bilge under the vip bunk. It is not coming from the sump box and don’t see any plumbing leaks. Has anyone had this happen and if so what was the fix.
  4. Pierpressure1

    Surveyor Needed

    Thank you
  5. Pierpressure1

    Surveyor Needed

    Does anyone have any suggestions for a surveyor in Annapolis?
  6. Pierpressure1

    System Monitor replacement for mechanical engines

    I would like to thank everyone that contributed to this replacement option for the system monitor. My original unit was inoperable the last couple years and I felt like I was living dangerously not having it so I made it a priority to complete this mod over the winter. Last week we took. the...
  7. Pierpressure1

    40 sedan bridge forum

    I found part at the end of the cables in the engine room. Defender was able to cross reference to latest version.
  8. Pierpressure1

    40 sedan bridge forum

    Here is the part number for the 28’ cable for starboard. You need the 26’ version for port. Thanks for the interest in Defender. The current replacement for that part number is our item number 302021633-28 selling for $63.99 each plus the shipping and tax (where applicable). Here is a link to...
  9. Pierpressure1

    Official Caterpillar3116/3126 Thread

    Thank you for the quick response. I will look into those suggestions.
  10. Pierpressure1

    Official Caterpillar3116/3126 Thread

    I have been using Rotilla T1 30 weight.
  11. Pierpressure1

    Official Caterpillar3116/3126 Thread

    If it is burning oil it is very little. Level on the stick stays constant between annual oil changes.
  12. Pierpressure1

    Official Caterpillar3116/3126 Thread

    Just pulled my aftercoolers. Both of them are coated in oil. Had them off and cleaned 5 years ago and don’t remember them being this bad. Any input on what could be causing this?
  13. Pierpressure1

    40 sedan bridge forum

    Does that breaker provide power to the float switch or the switch at the helm?
  14. Pierpressure1

    40 sedan bridge forum

    I just moved the new thermostat behind the starboard couch.
  15. Pierpressure1

    40 sedan bridge forum

    Went to check on the boat today and discovered the float switch for the forward engine room bilge pump was not operational. After troubleshooting I discovered the wire that supplies constant power to the float switch only has 10v. Spent a while trying to trace it but had no luck. All batteries...
Back
Top