Would anyone have any pictures of custom hard tops on Sundancers 320, 340, 380?
I'm looking for some design ideas for my planned conversion on my 340.
I've found a fibreglass shop that can do the work and they already did a 340 conversion a few years ago.
I'm looking to get something like...
Thank you, I'll look into it for the off season project. I also have to look into replacing my holding which my marina blew out with a pump out gone bad.
Not to revive an old thread, or old (possibly bad) memories, but as anyone find a permanent solution to these crappy fridge problem? Been having issues with this fridge for a few years, even replaced the power module with the recommended MPS 50 and still having issues. When connected to shore...
Thanks for the info.
After over an hour of digging through the harness I was still not able to locate the specific wire #527. All the wires of hte same color I traced ended in the bilge DC panel. I haven't opened up all the harnesses yet so I'll keep digging at a later date. For now I found an...
Thanks, I'll keep digging. I opened the DC panel in the bilge but couldn't find a connector, or a pig tail with open ends. If any of you would have a picture of what I should look for that would be helpful.
Thanks
Hey y'all,
Anyone would know where the connectors for the two switches ACC1 and ACC2 would be located? Wiring diagram lead to the DC panel in the bilge both couldn't find where to connect the accessory I'd like to be turned on/off with the switch.
Thanks for the tip! I was actually wondering the same thing as I am getting ready in the next few weeks to put my 06 340 Sundancer to sleep for the first time.
Pat...
Hi All, well here is a little update, if anyone ever come across a similar problem.
After many hours of troubleshooting I was able to isolate the problem to a particular sensor, and this morning my mechanic was finally able to make it down my marina with his mercury diagnostic computer and...
Hi all,
I'm new to this forum as I am a new Sea Ray 340 Sundancer (2006) owner. I've been following many of the threads and got valuable information so far. This new (to me) boat is my 5th in 20 years so I'm not a complete newbie, but I'm new to 8.1S and V-drive engines.
Today, while on my...