Recent content by Pachanga2018

Top of boat from the windshield forward to the bow..

Hello,,,I am wondering if i can walk on the frontend of my Pachanga 22,,,it doesnt look like i should,,but will it hold 200lbs.. now and then,,,Thanks

Thanks ,,I was looking at the wire used in the sensors,,,found a brand that said ,,Made of tinned wire,,,good chance this is were the issue lies.... Should I still switch to GPS Speedo?? Also ,,would I have to pull the drive to put all the New wiring through,,I would assume so

I just read a thread from Monday,,and it really leans me to New limit switches,,,I do have the Trailer switch,,so plan o just bummimg that abit and see what happens. I have read a lot about not doing this at much RPM's,due to the support issue,,should not even attempt??? Check fluid,,All Good...

Second Issue,,, Speedo will only go to 42,,I know I am doing Way more then that,,,I replaced the broken pick-up. Do they make pick-ups that only go so for,,I bought on E-### I just got done buying acouple Apps for my cell phone for a GPS Speedo,,tested both out in my car and both were spot on...

Hello to All,,,I finally got this boat out 3 times last week,,,,Ran Great,,But need some help on the Trim. When I put the trim fully down,,the gauge still reads 1/4 up or first line. Pops out of the water Great,,I go to trim it abit and the gauge barly moves.I know I am still raising the...

Thanks,,I ran out of time yesterday to check for some kind of tube under the motor..That is what I am hoping is on this thing..

Hello All,,,Was going to change engine oil yesterday on this boat I bought ,,I bought one of those Sure-Flo bucket w/pump,,problem is the tube won't go down dip-stick tube. I was thinking of trying to add a hose to the oil pan drain plug area and then adapting to the line from the bucket pump...

I sure wish I had done some research before I boat this boat last fall,,,but I will run it this summer,then trade it for a 27ft Pachanga with Bravo drives.

:: Update :: I found a Service Bulletin that explained my questions. In 1988-89 MerCruiser made afew different power packages for SeaRay using the 7.4 Magnum. 7.4SRX is V-8/454 CID/2 Bolt Main/Alpha Drive 7.4SRB is V-8/454 CID/2 Bolt Main/Bravo Drive 7.4SRX-H is V-8/454 CID/4 Bolt Main/Bravo Drive

That could be just what they did,,since they found out they made a mistake with that package!!!

The Alpha Drive was used on my model for 2 yrs..And I happened to buy a boat that has it. Wish I knew what I do now ,,last Fall !!!

I have read that to ,,,but I am just trying to figure what the main differences were from the Mag Alpha to the Mag Bravo motor.

Hello All,,, The flame arrestor cover on my engine has a decal that says SRX7.4L I found a chart that says SeaRay used a SRX7.4L (454 Mag Alpha) ,and a SRX7.4L-H (454 Mag Bravo) in 1988. Does anyone know the differences in these 2 motors? Is it a 330HP. motor? There was also a 7.4L Bravo...

I was able to locate a set for 58.00 shipped to me,,I didn't think that was too bad of a deal.