Recent content by notlaw

  1. notlaw

    Searay 340 Keypad

    Hi there, My port side keypad shattered when I was replacing a switch. It's for my 2006 - 340. I found this https://www.ebay.com.au/itm/282022572194 on ebay, but there's none in stock. Has anyone had luck getting the piece of trim, or a new keypad like in the ebay listing?
  2. notlaw

    Hit a mooring, shaft is wobbling

    That could very likely be the case. Also - I found out today the mechanic mis spoke, the cutlass bearing is pretty worn on that side (which could be contributing as well). What procedure should I follow for re-alignment?
  3. notlaw

    Hit a mooring, shaft is wobbling

    4 weeks ago, we hit an un-marked mooring while in gear (no throttle, 700 rpm ish). Heard/felt a decent bang, took it out of gear, waited a min, then we were clear of it and we continued on. I kept an eye on the bilge and noticed one of the shaft seals (tidesmarine "dripless" sureseal) started...
  4. notlaw

    Upgraded batteries, do I need a bigger battery charger?

    I have a very large stereo system, I use lots of battery! My charger is: Make: Inteli-Power Model: PD2040 Input: 105-130 VAC 50/60 Hz 650 Watts https://www.progressivedyn.com/wp-content/uploads/2017/04/PD2000MarineManual.pdf Are you sure the generator shouldn't be charging the batteries while...
  5. notlaw

    Upgraded batteries, do I need a bigger battery charger?

    Hi there - I installed 6 of these, group 31 AGM batteries, 105 amp hours each. 4 on house side, 2 for starting. I also switched the house bank and starting sides so I could fit the 4 batteries on one side. And I upgraded the alternator on the house bank side to 105amp. So, couple questions...
  6. notlaw

    Steering to the right is stiff under power

    As the title says, when I am under power steering to the left is a breeze, going to the right is quite stiff. I believe my mechanic checked the hydraulics at the back and they were fine. What are the most likely culprits? Rudder bushing? Thank you
  7. notlaw

    2006 Sundancer 340, 8.1 HO

    2006 Sundancer 340, 8.1 HO
  8. notlaw

    Helm Switch On-Position Not Working

    My starboard side helm switch doesn't turn on the smartcraft gauge for the engine when switching to the on-position (and doesn't fire the relay on the engine). It starts the ignition when I fully press it, but the middle position on the switch doesn't work anymore (it stopped working randomly a...
  9. notlaw

    Miami Mercruiser Mechanic

    Looking for a good mechanic in Miami to work on Searay 340. Cutlass bearings, shaft seal, propellers, and a few other things in the engine compartment. Twin merc 8.1's, 2006
  10. notlaw

    340 SeaRay - Crane?

    Hi there - I am looking to buy a 340 Searay, and one thing that got brought up by some boater friends is that the v-drives force you to crane lift the boat out of the water anytime I need something serviced (instead of hauling out with a trailer). Their thought was that since you can't tilt the...
Back
Top