I've tried searching many forums for this information, so my apologies if this is info is already posted. I'd like to drain the raw water from my exhaust until I have a chance to run the pink through the system. Thanks in advance as always.
Best,
Michael
All set..and thank you.
Thank you. Next question. When reinstalling the throttle body, does the gasket get installed as is or with some type of liquid gasket or similar? Thank you
That's an answer I was looking for. Might you have some advice on how to remove the exhaust tube from the elbow? I've used a pick tool to break the seal but could use some input on this if you have. Thanks much. Greatly appreciated
Good morning - When replacing the IAC on my 2000 starboard engine, if removing the plenum to get to the throttle body, is it necessart to remove the riser/elbow and exhaust tube? I've been getting some mixed advice on this. It seems if the plenum is removed, the riser and exhaust tube are no...
Makes sense. As an FYI, all injectors were replaced with new and or ultrasonically cleaned ones while both engines underwent install of new OEM Merc head/valve assemblies, distributor assemblies, and full tune ups. Was not expecting this issue to reappear which was present prior to the rebuilds...
The frustrating part of this is originally, the port engine was looked at by marina mechanic (no personal mechainics permitted on premises) for a different issue when upon initial look/see he observed a broken #7 injector which was suggested to be replaced. Upon replacement #5 was broken (I've...
Good afternoon -
Subsequent to injectors being replaced w new, port engine presents with rough/vibration from idle to 2200 rpms then she's running like a top after engaging throttle to 34- 3600 rpms. Mechanic states system scan shows ECM is flooding one bank of injectors (3,5,2,8) with fuel as...