Hi all
2004 280DA with smartcraft. MY depth shpwing dashes, does anyone know
1. what model OEM tranduscers are installed so i can look for a replacement
2. are there aftermarket ones available
3. is it best to leave it and install a new one somewhere to connect to my raymarine A98
thanks
Hi all I'm looking to get my Mats done over in foam and the company has a 2006 template only. ANyone know of any differences between the cockpit layouts- pretty sure they were the same from 2002 to 2007
Thanks
Thanks. I started it up yesterday let it run for 10 minutes straight with ac, microwave and stove running and seems to run fine now. Maybe the gas smell was flooding from too much cranking?? Going to let it run longer later . Appreciate all the advice
Mine is a 2004 as well. Thanks
As far as water flow it's normal. Didn't let it run last 5 minutes to see if would go away though. Didn't know if I was shooting lot of gas in the water so shut it off.
Hi all
Have a sundancer 280 with 5e generator. Its running but the exhaust port where the water comes out has a frothy gas smell. Any suggestions on what the issue is? Gen does not get used much-i know they must be ran but always forget to run it even when not needed just to keep it running...
Hi All
Sundancer 280 with the dual mercury throttle. The port side top handle (black part) is loose and spins. Is there a set screw somewhere to tighten it? Or do I need a new handle. Ive seen handles but mine has the dual trim buttons and ones I see don't have. Or is it universal and I need to...
My advise is to put it on a kedar track as well. I like to keep mine on while underway. I initially did snaps only. Spent 20 minutes fishing it out the great south bay
Hi. How name is Roman
Appollon Upholstery out in freeport.
(718)7020899
Tell him Marlon gave u his contact. Are you in LI? Good luck with the 280. Let me know if u need any advice. I've taken mine apart especially for the music and electronics.
hi all
Is there any other location or way to locate engine serial number. The metal tags on mine are unreadable and I need it for a repair
2004 sundancer 4.3
so we swapped the ecm and engine fired right up. Any one know where to source another one or if its common to have them repaired. Also are new ones just plug and play ?