Recent content by Mark D

  1. M

    How to Tighten Up Weak Front Passenger Seat-Back (Sea Ray 400 Sundancer)

    Thank your, sir. Your logic is sound. 25 years will take its toll on most everything.....r/Mark
  2. M

    How to Tighten Up Weak Front Passenger Seat-Back (Sea Ray 400 Sundancer)

    Bruce....No sir, the only visible hardware is the screws that secure the entire seat to the deck. I don't see an obvious avenue to deconstruct the seat base from the seat back. Once I figure this out, I hope to post findings for others. Sincerely appreciate your reply...r/Mark
  3. M

    How to Tighten Up Weak Front Passenger Seat-Back (Sea Ray 400 Sundancer)

    Greetings, All Regarding the front passenger seat next to the Captain's chair, the seat back has become weak. It pushes aft easily....unnaturally. Has anyone suffered this situation, and if yes, I'd sincerely welcome your feedback in advance. Happy boating...r/Mark
  4. M

    410 Sundancer/Express Cruiser and 400 Sundancer/Express Cruiser **Official Thread**

    Josh...Not a HVAC guy, but that smells like a startup capacitor issue....could be failing to provide necessary amperage and thus is overtaxing the supply circuit......
  5. M

    Replace ACR Spot RCL-100D w/ RCL-75? Has anyone made the swap?

    Hello, All.... This is a very old thread but hoping to poke the nest to see if anything returns. Thanks in advance to anybody who can chime in. 1999 400DA...Spotlight replacement project. Bottom line up front....I need to either 1) locate the legacy spotlight RCL-100D's master control module...
  6. M

    Replacing Halogen with LED

    Greetings, All.... For our 1999 400 DA, I replaced all below deck halogen bulbs with Satco S9542 LED G4 1.6W 12V. These bulbs use all the available real estate, but they fit. Regarding getting to the bulbs, you need to be a careful. The entire housing must be pulled from the ceiling. The...
Back
Top