I've removed the line to the carb and fuel is being pumped but have not checked the psi which is between 2.0-3.5, I guess I need to measure that somehow to rule out.
My generator now has approx. 1900 hours on it and it has been very reliable. Towards the end of last boating season I noticed it began to hunt and I put off diagnosing it until this Spring. Well, I haven't had much luck finding the culprit. I am usually good about exercising the motors during...
Has anyone had the privilege of changing out the crankcase cover gasket on their gen? I have an oil leak and think it may be the culprit. I had the oil seal behind the fly wheel replaced last year as it was leaking and now this.
Need help with issues I’m having in the engine room. I’ve been on here several times regarding some problems I’m having with either my transmissions or shaft seals/bearings. Since I’ve owned the boat I am getting a sporadic alarm (more of a faint beep) when I shift the transmissions either from...
Need help with issues I’m having in the engine room. I’ve been on here several times regarding some problems I’m having with either my transmissions or shaft seals/bearings. Since I’ve owned the boat I am getting a sporadic alarm (more of a faint beep) when I shift the transmissions either from...
Need help with issues I’m having in the engine room. I’ve been on here several times regarding some problems I’m having with either my transmissions or shaft seals/bearings. Since I’ve owned the boat I am getting a sporadic alarm (more of a faint beep) when I shift the transmissions either from...
Just purchased a MW1 remote and ext. cord. Unfortunately the 25' ext. cord is not long enough, can I buy another ext. cord and plug the two into eachother?
Well i made the move and installed the CMD7, it was a plug and play but i wasnt able to run the aux cord or the usb cord to the helm as i planned. I originally was going to secure the cords to the existing remote wire and pull it through but no luck, it wouldnt budge. So i wil have to look into...
ok, still need some troubleshooting advice. Today i replaced the plugs, oil is good, water flow is good, choke/throttle are operating normal. Next step is to replace fuses and inlet fuel filter. I have to order these parts, I have never replaced the fuel filter and not sure if it ever has been...
Started my gen today and she fired right up and after bout five mins she started to surge then shut down. It will fire back up but then surge and shut down. Anyone have any suggestion s where I should start? It shut down with load and i checked the fuses and they are good.
Sorry, it's a Kohler...
Haha...sorry about that!!! Well, I did fine the problems and thankful it's an easy fix. There is a black coupler on the main drive shaft and the shaft to the water pump that broke in half therefore no power to the water pump. Just have to find the replacement part.
ok...it's late, been a long day and i have had a few so bare with me. I have a 7.3 kohler gen, running most of the day with no probs and then all the sudden no water dishcharge from the exhaust. Ok....seen this before and i had a spare impeller on board so proceeded to replace the old with the...