Recent content by Labbur

Hope all is well. I am in the process of replacing my fresh water pump. ( 44 Searay DB 2008.) Factory installed Shurflo 5901-0201 started the same old issues all talk about. The pump started to increase pressure and drive water out through the hot water relief valve. I have adjusted it twice and...

I have one installed from sea ray. It works great but runs very hard on sunny days. 1,600. Crusair unit. It blows 56 degree air with water temp coming in unit at 89.1 degrees. I really think a bigger unit with all the glass is needed. If I can help with more info, would be glad to. As info, I...

You are correct. Whole center comes out and then air unit. Have you checked the drain to make sure water not backing up

I bought parts and ext it so I could reach it. I can email pic if you wish. Just too hard to get to so I ext it

Update on subject of pulling the tran filters. Tool was found at napa to get them out. Put a small pan under the filter to catch the oil, worked great. Did have small amount of metal filings on mag on the end of the plug. Filters cleaned no issue. Hardest part was finding the socket and breaker...

Try wet sounds very good results

Alex is right on I bought the bolt from home depo. Had less bells and whistles. I hope you can use the bolt makes it simple

What type do you have? The type pump and impeller is needed. I pull my 2600 with a 2/4 bolt

Re: 420/44 DB Owners Club Onan how often do you replace the resonator intake part 140-3078-01 on a 2008 MDKBM Onan Generator. Can not find any hour requirements at Onan

points well made

So much depends on how you use your boat and what type water

Thought I would post a little testing data on impellers. My boat was built late 2007 ( 2008 model ). I now have 300 hours on the qsm 500 so I decided to service the impellers. Now keep in mind since I bought it new the temp rises and remains the same during warm up and running on both engines. I...

Any good Crome polish

Re: 420/44 DB Owners Club transmission filter I posted a discussion on how to clean out the filter on my zf280 1a 44 db 2008 boat. Thanks for the replies. I did figure out how to do this. First room is a real problem. This was solved by buying a shallow drive 3/8 socket 36mm. Hard to find but...

Short reply for now. I posted a full report on this subject. Please check all my post on this. I pointed out water flow is a real issue. I would suggest a 1,800 but you need a pump that max the water flow. This site had a good conversation on water flow and how to get max flow. My 1,600 runs...