We've got a 40 Sundancer with QSB425 V-Drive ZF Transmissions (ZF 85 IV) that the starboard transmission started making noise when in gear at idle speed. The boat ran fine, trans temps, pressures and fluid levels all check out but the noise is very noticeable. Looking for some direction...
Looking for help the door stop / latch for the door into the cabin has a small spring on it, mine broke, now the finger doesn't clamp down on the catch mounted on the door. Does anyone know if I can source the entire part or how to replace the spring? Photo attached.
I see you are a regular contributor and live in the Lake Lanier area, I’m looking for our next boat and found one down your way. Would you have a surveyor and diesel mechanic you would recommend?
I'm speaking of the center vent within the windshield, it's leaking and running around the inside of the dash and draining out the side. I'd like to replace it but don't want to remove until I have an idea what to replace it with.
I know this has been approached before but I haven't seen an answer, the gasket for the center vent window has anyone found a good solution to replace???
We have a 320 that had a leak in on one of the portlights, you can replace the gasket by contacting Bomar directly and I would suggest also taking the portlight out and reseal. I took ours apart this past weekend and it appears it was never caulked at the factory if that is possible.
I'm looking to remove because I'm getting water in my radar arch and want to take the grab rail off, seal and replace, top bolt is easy through the speaker bottom not so much.
Question regarding the junction box on a twin engine application, if I get a 6 port junction box do I need one resistor or two for VV Mobile Installation?
Correct me if I'm wrong but I believe 3M 4200 is for non-structural and 5200 is for structural bonding. I was just researching it yesterday to reseal a portlight.
320 Experts, I'm looking to upgrade my Raymarine TriData depth transducer and bring it in to my Garmin GPSMAP 740, can anyone tell me the size of the thru hull transducer? Also my parts manual shows if offset and ours is dead center in my 2003 320. Any transducer recommendations are welcome as...