Engine is definitely shifted into neutral. I took it out of gear before shutting off the engine. Just to be sure though, I shifted it back and forth a couple of times just now, no change. This is the carburetor model, with manual shift cables and throttle cables, if that makes a difference.
The...
Hi all. 1981 Vanguard 310 with twin 5.0s
I went through a lengthy process to get two remanned engines put in last year. Boat finally went back in the water last fall. Unfortunately, I travel extensively for work so this week is the first time I've been out to the lake to use her this year...
In looking around for info about my 310, I heard that they made a 360 Vanguard in the early 80s. Does that one you saw look like this?
http://www.searay.com/boat_graphics/electronic_brochure/company1729/1C1_27_74DERNJ51330.jpg
Re: 2015 Lake Erie CSR Rendezvous (Sea Ray New Year) Paper district Marina Sandusky O
Are boat-less attendees allowed? I'll be in the area but my boat is quite a long way south.
Any members here have slips in Fairport Harbor? I'm up here for work and yesterday I drove around a little bit, despite the nasty weather. I saw a few gorgeous classics docked along Riverbend and at HTR right on the lake. Hopefully none of them were bothered by the storm surge. I saw one small...
I've looked all over trying to find this info, with no luck.
I have a 1981 Vanguard 310 Express and I need to know the deadrise angle of the hull to order a thru-hull transducer. Stupidly, I forgot to measure it last time I was out at the boat. :smt021 I want to get it installed while the boat...
I'm looking for the shift levers and throttle levers for a 1981 310 Vanguard. I'd like to install original-ish parts if possible, but really any lever set that is built for non-electronic engine controls would work. My engines are inboards, so no trim switches needed.
Thanks for looking!
Evan
Thanks for all the replies and well-wishes! This is certainly an exciting project and I can't wait to get the old girl back out on the water. The old motors are coming out this week, so hopefully I'll have more pics to share soon.
I am going with a full MerCooling closed-loop system. My...
It has been an eventful winter/spring!
Recap: I purchased a 1981 Vanguard 310 in July of last year. The interior was in quite a state (tobacco tar stains on all the vinyl, interior hadn't been cleaned in ages, ragged carpet, etc) and the engines didn't seem to be quite right (~2800 rpms @...
I have a set of shutoff valves that allow both engines to draw off either tank, both tanks, or their respective side tanks. The valves are mounted on a panel in the center of the forward engine room bulkhead. Right between both engines. I open the center hatch to access them.
If you backtrack...