Recent content by Jon Paul

Sold

400 fair?

Arizona.

Not sure. You would have to check diameter and shaft size.

I replaced mine a couple years ago after one sustained some minor damage. I always intended to have it repaired, to keep for spares, but never got around to it. I now have sold the boat. Best offer, you pay shipping Star 18x21 Port 18x21.5 1.5" shaft CUP 9

Yes, I heard it is to compensate for counter rotation of trans.

If you use your built in coffee maker, it could have a leak. We had the exact same issue and finally found it was caused by a leak from the back of the unit. when coffee was made.

If the damage, crack, was caused by a bad prop pull, there likely would be insurance coverage. Depending on your specific policy. Take it from a insurance guy. : )

Yes it was the same. You will need to cut the ports that you need, as they are sealed.

I used this and have been very happy. Replaced mine about 4years ago. https://www.amazon.com/dp/B07DCQDD4K/ref=dp_cerb_1

Do you use the coffee maker that is part of the micro? If you do, check for a leak there. We had one there and took me a while to figure out.

Congrats! You are correct. What we did was put a motion sensor battery operated light that sticks with a magnet to the wall. Works perfect.

If I remember right they are reversed threads. Are you trying to turn the right direction? Sorry if an insulting question but I broke one making that mistake. : )

Try a hot glue stick. Melt of end on lock, let it dry, and the pull. Should come out. JP

Check with Quint(CanvasMedic.com). We had him do our Infinity woven vinyl snap in carpets and they are awesome!