Recent content by JoeV

SeaRay Systems Monitor LCD Readout Panel & Monitor Interface Module Used and in working order Parts Number: MM2549635 & MM2549634 Removed from my SeaRay 2001 400SD. It was thought to have failed however when replacement parts were installed and did not respond. We found a loose coax connection...

Hi Mark, Needing to change my cutlass bearing on my 2001 400db. A member referred me to you as you have done it. Which bearing did you use? I have a guy with the hydraulic set to push the bearing out but not sure what bearings to order. Thanks for any and all help. Best regards.

We tested drilled out one of the plugs and attached a boost gauge and we had plenty of boost. I suspect the reassembly of the turbo screwed things up. We will check it our. Thanks again.

Thank you. We will check it out. The yard mechanic may have damaged it.

Will do thanks.

Hi Mark and Karen, Thank you for answering. This all started after the tyranny work and new gear cooler heat exchanger. When the yard did the service they noticed a leak in the mixing manifold and replaced it. They broke one of the bolts and needed to remove the turbo and the housing to extract...

Issue with my 2001 400db. When throttling up Starboard engine the rpm’s stall at 1,400 even at full throttle. Throttling up the port engine does not effect or change the condition. After a few minutes the Starboard rpms start to climb with a surge based on the fact that the throttle is set to...

Hi Bill. Thank you for the information. Between you and Mike I am al ost ready to roll. I was also able to get a quote from Garelick for replacement shocks which was more reasonable than Aegis. Aegis USA has yet to call me back. Testing the height today. Hopefully it will be tall enough...

Thanks for the reply. I was finally able to make contact with Asgis-Hahn in Germany who quoted me over $250.00!! To ship them directly. The unit cost was about $87.00 each but the shipping, handling etc... adds up and they are “promising” 3-4 week delivery. Considering they want payment up front...

Yes very interested I need two of them for my 2001 Sedan 400. The pedestals on both helm seats failed. The retaining screws sheared off and the pilot seat went free wheeling then tilted off and bent the piston. Tried to contact Aegis-Hahn but website won’t take info and their email address comes...

I was hoping someone else has had this issue and solved it. Whenever it rains my cockpit rugs get saturated. The water comes in from the gunwalls onto the steps and then to the deck. I have narrowed it down to: 1. When we bought the boat it did not have cockpit canvas and we had it made. Is...

Since the topic of cockpit carpets has come up we are having a devil of a time with ours. We had cockpit canvas made for our 2001 Sedan to keep our carpet dry. The problem is whenever it rains hard water comes in from the gunwales onto the bridge/gunwale steps on the Port side and the gunwale...

Didn't realize that was an option considering its age. Definitely will look it over when I take the old one out and if worth doing will save it for a spare. Thanks for the tip.

Hi there. Joe here from Port Washington Long Island. I have the exact same boat and genny and my Centek Muffler just started taking water and will be replaced as soon as I can find one. I would love to replace it with the custom one you mention but the season is too short to wait so I need to...

I have the very same problem with my 2001 400DB. In my case the gasket has shrunken to a point were it is not longer useful. A previous owner attempted to repair the leak with Silicon but it didn't last. Does anyone know were you can get the rubber molding/gasket? Thanks for any and all help.