JimG's Recent Activity

  1. JimG replied to the thread WANTED: Northstar NS100 Handset.

    Added a picture to my post...

    May 24, 2018 at 2:27 PM
  2. JimG attached a file to the thread WANTED: Northstar NS100 Handset.

    Might be the right cable, but it won't be easy to replace... both ends are molded to the cable. The mic end has a very small connector...

    20170810_195311.jpg May 24, 2018 at 2:23 PM
  3. JimG replied to the thread Speedometer Issue.

    The plug in the bottom of the boat sounds like your depth sounder, and the one zip tied is a dummy plug to put back in the hole if you...

    May 24, 2018 at 8:08 AM
  4. JimG replied to the thread changing bulb in overhead light fixture on a 1996 370.

    Those may pull straight down... spring loaded "mouse trap" like.

    May 22, 2018 at 4:05 PM
  5. JimG replied to the thread Electrical HELP.

    I looked at your schematics also and there is no connection between the starboard switch pad and anything else. The pad connects only to...

    May 22, 2018 at 2:13 PM
  6. JimG replied to the thread Broken snap screws.

    Yeah... if you cant drill them out, I would just add a snap beside it and add the new matching one to the canvas.

    May 22, 2018 at 1:34 PM
  7. JimG replied to the thread Can you splice anchor chain via proper welding?.

    When I went all chain I added 150' of chain to my existing 25' and used this link... as Kevin says, goes through my windlass just fine.

    May 22, 2018 at 1:31 PM
  8. JimG replied to the thread Boat hook / Brush handle.

    There is also in insert that comes with it for inside the tube. If it floats collapsed, why would it not float extended? Might change...

    May 22, 2018 at 10:06 AM
  9. JimG replied to the thread 300 Sundancer converter.

    cfd95 provided spot on comments... just a couple more to add... The dual charger outputs are isolated so your batteries are not...

    May 22, 2018 at 9:46 AM
  10. JimG replied to the thread Boat hook / Brush handle.

    BTW, they make a thread head adapter so you can use your existing brushes, and as Kevin pointed out they make a "Handle Mate PFD"...

    May 22, 2018 at 9:25 AM
  11. JimG replied to the thread Boat hook / Brush handle.

    I like mine... got a couple of different brushes and the hook. I didn't have any existing pieces so that was not an issue for me.

    May 21, 2018 at 2:48 PM
  12. JimG replied to the thread Electrical HELP.

    The electrical panel is not tied to the pads or EIM's... sound like just a coincidence. Check the connections from the pad to the EIM....

    May 21, 2018 at 12:00 PM
Show Sidebar