Recent content by JasonS

So, if the drive is up it could catch water and freeze? Does it matter that the swim platform covers the outdrive and its covered with a tarp?

Yes, the drive is all the way up

Hi everyone, I live in PA and was outside plowing snow. I checked on my boat and saw pink on the snow below the outdrive. I put my finger on the intake holes and it was like a water oil mix. Not sure what's up. Any ideas would be a big help (I'm a little worried)! The boat was winterized by a...

I did not have the motor compression tested. I did new manifolds, risers,and spacers. They upgraded the gaskets that came with the manifolds. They said the rust on the cyclinder heads not sealing well is causing a ticking noise. If not addressed it could lead to valve damage. I asked if they...

Here are some pics sent to me. There is a ticking from that side when the motor is on.

Hi everyone, brought my 240 Sundeck to the dealer for a exhaust manifold and riser replacement on my Mercruiser 350 mpi. During the work, the dealer called and said it would be a good idea to replace the motor heads because of some rust. Anyone run in to this problem? Anyone who replaced them...

Is the years of service for the barr manifold for salt water or fresh water? My primary boating is a fresh water lake.

Hi, honestly I have no idea if a new fitting will help it. I’m going by what the dealer said needed to be replaced.

The cool fuel module is leaking from the body and needs to be replaced. I need the part number to search for it. I don’t think it isn’t covered by any recall.

I have a 06 240 Sundeck with a mercruiser 350 MPI. I need a new cool fuel module and a exhaust riser and manifold kit. Where is the best place to look? I’m looking online and I can’t find the part number for the cool fuel module. Any insight would be helpful, thanks!

How do you get a new cool fuel module from mercruiser? The engine is an 2006? Isn't the motor out of warranty?

Hi guys, got some news today. I need manifolds, risers, and a cool fuel module. Does anyone know what that might cost? I have not got my estimate yet. I have a 06 sundeck with a 350 mercruiser. Thanks

Sorry guys, this should go in to the gas motor thread. Unsure how to switch it.

Hi everyone, I have a 350 mpi mercruiser in my sundeck. Today, I was cruising at about 3500 rpms. When I slowed, I heard a loud ticking noise coming from the motor. I stopped and brought it to idle. I opened the hatch and saw that there was some water dripping from the side of the...

I was thinking of adding docking lights to my 240 Sundeck. I saw that Attwood makes a surface mount docking light that only needing a small hole in the hull. Has anyone used these? Pros and cons? Thanks