contact the marine ac companies. marine air? https://www.marinaire.com/
they would know better. most boats are made for ac but some cheapo didn't take the option when new. you should be able to do the job yourself if handy.
hi all, think I have a jabsco light with a ray line switch. light used to go on and light would only move into the down position. now nothing. I know I need to test the switch and power to the light. but I don't know how. I have some voltmeters. please help. thanks in advance. I did check some...
that does seem basic and simple. thanks for the tip. question . do I disconnect them one at a time when the alarm activates and will it shut off when disconnected?
Intermittent engine alarm 1990 310 Sundancer I searched with few answers. My boat just went in the water for the first time in 2 years. On land and motoring over to my slip from the lift, all seemed fine. I took her out for a shakedown cruise and did not get far. As I throttled up nice...
I searched with few answers. My boat just went in the water for the first time in 2 years. On land and motoring over to my slip from the lift, all seemed fine. I took her out for a shakedown cruise and did not get far. As I throttled up nice and easy to get on plane, the port ( 5.7 inboards)...
can someone give me a few possibilities why all my dash lights are out? I have 2 gauges for everything (2 motors). my nav lights work . I have a knob to brighten or darken the dash lights. it has to be one wire somewhere under the dash, but which one? thanks, rune
problem solved. The port motor finally started with the swapped fuel pump from the starboard motor. And now the starboard motor will not run with the fuel pump from the port motor.new fuel pump is on order from eBay. Should have it in a couple of days. Thanks to all who tried to help
Hydro, this makes the most sense to me. TonightI will check the fuel lines to see if there are any openings.your boat probably has the exact same system as mine, so where did you end up buying your replacement fuel lines? They look like hydraulic clamps with threaded fittings. how tough or easy...