Recent content by iluxa

Tried resetting the controller, didn't help. Started to mess around with the unit itself. Cleaned off all possible connections and removed one of the ducts to check if the fan motor spins freely, it did. Spun it by hand back and forth, cleaned it with compressed air. Put everything back together...

Just got to the boat. Its a Cruisair - SXF7/1 - RMT. Is there a fuse somewhere on the unit itself? When I turn on COOL on the controler, I can hear it kick in, and water begins to flow. However the fan never kicks on. The unit shuts itself down after couple minutes.

Has anyone had this happen to them before? My AC turns on, water comes out the exhaust fitting, but the fan doesn't kick in and circulate. Not sure what it could be or where to even start to diagnose. Could it be the controller itself?

I want to install 2 OceanLED A16 Pro Xtreme Lights. I was wondering where do you guys tie in your transom lights to? Also does anyone know where the accessory switch wire run? It has an empty spot on the breaker panel. Does that mean if I want to run my lights to it, I would also need to put in...

I want to install 2 OceanLED A16 Pro Xtreme Lights. I was wondering where do you guys tie in your transom lights to? Also does anyone know where the accessory switch wire run? It has an empty spot on the breaker panel. Does that mean if I want to run my lights to it, I would also need to put in...

Planning on crossing over to Bimini on 06/28 coming back 07/03. We have 2 jet skis and a 26 foot Sea Ray Sundancer chase boat. Its our first time crossing. If anyone would like to join or have any advise please let me know!! I know ice and food is really expensive over there so we are trying to...

BUMP. Any help is greatly appreciated!

Hey guys, here is an update since my last post. I replaced the thermostat with a new 160 degree one. Cleaned the thermostat housing out. I took a shop vac and attempted to suck out any debris that could've been in the two lines at connect to the thermostat housing. Took the boat out on the water...

does it look like i need to replace the thermostat housing?

Fresh water. Delaware river. Risers were replaced about 2 years ago. Replaced the impeller yesterday and replacing the stat today. Will go for a test ride right after. Is there anywhere a line could get clogged? After all, the Delaware isn't the cleanest river.

Can somebody please help. My engine overheat alarm keeps going off. It only goes off if I have the throttle above 3400 RPM. Anything less, the temp stays normal. I have replaced the impeller, however when I took the old impeller out, it did not have any wear on it. I will be replacing the...