Recent content by Hell Froze Over

I did a bunch of research and if you look at the models built after ours they are tinted. i.e. the 510 and 540's with full glass. Also, Sunseeker and Azimut have all of their windows tinted and they still drive at night. I was on a 2010 50'(same as our boat but with pods) that had 5% tint...

Thank you both and it was $2500. Ceramic is a lot more expensive than regular automotive dyed film. It took 2 tinters from 7:30am to 6:00pm to do it with no breaks. I figured the material cost around $1000 and the rest was for labor.

I finally was able to get a tint company to take on this project. Our front windows measure 61" top to bottom. Tint rolls only go to 60". Instead of using a residential or commercial tint roll (they are larger) that would not look right we put a small splice down by the dash. You can barely see...

No, I just had them make the canvas and sun pads. If the ones you have are basically brand new, and they are still popping up, I would replace the bungees on the back that hold them down. There should be four posts and the bungees should be tight as hell to stretch around them. If the company...

Shape, I had the same problem. Since mine were getting faded I contacted GIOIA Sales, Inc. They did all of the canvas and Sun Pads for all of our boats. They shipped me new ones, with all the hardware, new Sea Ray name stitches, and stainless cup holders for $1200. I have never had them lift up...

Thank you everyone! Once I disconnected the smartcraft harness on the starboard, and reconnected it, it started working. Now, chances are it is going to happen again. But, for now, it is back to normal. Since noone has heard of these diod harnesses Marine Max states it needs I would suspect...

Gentlemen, Need your infinite wisdom. 2008 Sea Ray 48 Dancer that was dewinterized. Everything was fine in October. Now, the vesselview and my tachs on the starboard side are not working. Engine runs fine. But, I do not have any readings on that side(gas, steering wheel, etc). Messed around...

Grant, Where did you find the wiper arm replacement and blades? I have one that is chipping and would like to replace them. Thanks and great job on all of your work.