Coastal Marine Customs covers Northern Michigan from their Traverse City location and fabricates SeaDek for Certified Installers in Southwest and Southeast Michigan. If interested in SeaDek, contact us now before the spring rush hits! #genuineseadek #seadekmichigan
Thanks for the insight, I'll run it over to the automotive guys. Where exactly did you purchase your vinyl from? A gGoogle search only gives me the on-line manuals for all of the boats with that specific material.
Were you able to get an exact match or did you redo the whole cockpit? I only need to do part but am having trouble with a close match. Lookin' at 5k to do the whole cockpit, does that seem out of line?
I have some interior that I need to replace and am looking for a match to the OEM white leatherlike textured vinyl for the cockpit. Anyone know who manufactured it or where I can buy it?
I too have had a Sierra impeller fail after 20 hours... replaced this spring and 5 of the 8 fins seperated from the base. It was a complete new Sierra housing and impeller this spring.:(
I have a 2000 380DA with 7.4 Horizons and had the breaker trip on the port engine after cruising for 2-2.5 hours. I was able to track the problem down to the black wire that runs from my fuel pump to the fuel pump relay approximately 1" below where the connector plugs into the relay. It seems to...
Find a sign shop that has some Scotchcal 225 and avoid any sharp points in the letters. Clean the dinghy with alcohol and apply. They will stick fine; but if you are constantly ramming the dock with them, they will not hold up.
I actually have a Sea Lift cradle setup on my 2000 380DA with twin 7.4 horizons and my dinghy is a 10'4" Zodiac RIB with a 15 horse merc (2 stroke) with 3.5 gallon gas can. I have had 10 adults on board 1/2 tank of fuel, tons of coolers, shore power cords, grill, etc. I have never had an issue...
Anyone have the same problem? I have a 2000 380 DA and the forward heater control started acting up (it will not allow you to increase the temperature, only lower) Now that it's stuck on 55 degrees with no way to raise it. Are these repairable, do I have to purchase a new one? If so, where do I...
Anyone have the same problem? I have a 2000 380 DA and the forward heater control started acting up (it will not allow you to increase the temperature, only lower) Now that it's stuck on 55 degrees with no way to raise it. Are these repairable, do I have to purchase a new one? If so, where do I...
New in Box a full set of canvas for a 1999-2003 380 Sundancer in toast (tan). bought direct from Sea Ray a couple years ago & sold the boat, never installed. Comes complete with everything except stainless steel bows. Over $5k new, first $2k takes it! Call 231.675.7720
If you give me the height, color and length of the stripes, I can check and see if we have some. We stripe a lot of boats and have a lot of "short" rolls on hand.