Separate names with a comma.
Here's a quick video of the setting up the table
I built ours using a sheet of PVC panel from Home Depot. It folds up and stores in the cockpit table holder in the engine bay.
When we had our 230, I ended up buying a Bolster Buddy. While it's not a perfect solution, it did make a huge difference.
I just realized that I didn't type what I meant to say. LOL
I just corrected my previous reply.
We have a 98 wide beam with twin 4.3's and we love...
Correct, the 9'-2"" beams had the walk-thru windshield and the separate dinette in the cabin. The 8'-6" beam had the walk-around and a typical...
Sorry to hear about your issues. Did you have a survey done before purchasing the boat (a mute point now but I was just curious if you did what...
I called Bennett and confirmed that it would be their "stanard" solenoid valve VP1135R (for red/port)
Does anybody know the part number for the trim tab solenoid valve that I would need for a 1998 270 Sundancer?
The starboard trim tab works fine;...
Here's one for the late 90's 270 Sundancers
No, I used a woven vinyl (similar to Xfinity) that I purchased on eBay, templated and cut to size. Then I had a local canvas guy sew on the binding.
I checked to see if it was a polarity issue by removing the alignment screw at the base of the pose and reinserting the light turned 180 degrees...
Ok, so we purchased a SeaSense telescoping LED stern light (part 50023963) for our 98-270 Sundancer (wide beam) which is for a standard 2-pin...