Just found a new/in box Fusion IP500G radio
w/o the remote ! Anyone know of or have this remote laying around from their upgrade ? Thanks. Ed. 330 EC. “Timeout”
Tranny is full and engages well in F and R. There is the usual 'chatter' at idle. My power steering is ok. So what could cause more than a gallon of
red, hydraulic fluid to show up in the Bilge ? Does the Trim Tab reservoir hold that much liquid ? And where the heck is the reservois located ?
I wish I knew of a way to make this a "Bulletin/Safety Alert" for every one connected w/ CSR ! The location of this Regulator is terribly hard to see and I was very lucky to have
had my hatches OPEN and used 'common sense' !! It takes two people to determine the problem, one in the bilge, the...
CAUSE - Ruptured ( Rusted) FUEL PRESSURE REGULATOR (43 PSI) that sits atop the FUEL COOLER/FUEL PUMP !!
SOLUTION - 1. Mouth Syphen or HAND BAIL all FUEL in Bilge !! DO NOT USE any 120-v Wet-Vac ,.....or allow fuel to be dumped over board via Bilge Pumps !
Turn OFF ALL...
Just changed plugs, and started Port side engine, only to hear a 'hissing' sound !! Smelled fuel (gas), looked down and there was 2-3" of fuel in bilge !!
Cannot see any fuel line cracks, nor locate the problem ! Fule pump/cooler appears in tact. Where in the heck can this much fuel originate ...
Thanks for your reply. The answer is yes! I have taken it, along w/ my switch to Marine Max. I have likewise, contacted SR, Customer Service, who tried their darndest to locate the actual dwg's, but to no avail ! I am over my head reading the wiring schematics, but have isolated all color...
Have just replaced all dash instrument and guage panels, and am having one heck of a time w/ the ignition wiring! I am getting ignition to both engines, but am not
getting any alarm nor fuel solenoid activity when I initially engage the rocker start
switch. I have asked Sea Ray, Marine Max, and...
Hey CSR's - Saw this,.....and had to reply ! Scott has just returned my panels for my '99 330 EC, and they are outstanding !! With reluctancy to 'pay up front' to help him out, I did so via Pay Pal, and he has lived up to every word and action that he promised !! In fact, he shipped the...
:smt100I am in the process of upgrading my intrument / guage panels, and am running into a 'proverbial' wall at every turn! From FPmarine to Fasco (via CS at Sea Ray)
nobody can locate or reference a place to locate it !! The same holds true for
my fuel and temp guages ! My 2000, 330 EC, built...