Recent content by gater61

Hey all does anyone have experience with converting the galley kitchen table to a sleeper on a 97’ 330? I’m going to dig around today and see if I can find any accessories/attachments. I’m thinking we don’t have the cushion but is there any hack to use or other accessories I’m not considering?

SeaDek (or similar) template for a 1998 330 Sundancer Anyone have a template for the cockpit and swim platform of a 1998 330 Sundancer? I'm not sure if 97' is the same measurements in the cockpit?

Gator Step floors has the template for the 1999 330 Sundancer. I have a 1998, anyone try using the 99' template? Issues? Thank you.

Appreciate it and yes that was it and I was able to pick one up and correct the problem. Appreciate the link.

Gauges all read okay, boat running great... BUT, if I cruise closer to 25 mph eventually port engine alarm will go on and remain on. (I tested to make sure it wasn't a bad sensor but when I pushed through the alarm I eventually noticed 'slipping'.) I got down and immediately checked trans fluid...

Gauges all read okay, boat was running great... BUT, if I cruise closer to 25 mph eventually port engine alarm will go on and remain on. (I tested to make sure it wasn't a bad sensor but when I pushed through the alarm I eventually noticed 'slipping'.) I got down and immediately checked trans...

Is there a trick to connecting to fresh water inlet? Is my connector missing something? Doesn’t feel like it should be so hard to connect and when I turn hose on water sprays everywhere.

I will be trying this thanks!

What would be causing my port engine alarm to go off? Gauges are all reading fine. It’s running fine and no burning smells coming from engine compartment. I shut it down for a while, start it up and it doesn't happen again. (it did happen twice while boating yesterday) Thanks all.

There is a panel beneath the cockpit sink that would give access to behind freezer, where the busted line is. I can not figure out how to get that panel out without cutting it in half. Hoping there is a trick to getting that panel out without doing damage.

Tim you are the man this is exactly what i needed. thanks!

Wow, thanks. Mike's a good guy. We're excited to get her home and be out on the water once the snow goes away lol

Thanks for the tip. I was looking for the deadrise and you posted it as 17 degrees so that is helpful. I finally tracked down the installer who does think the bunks will work, if not, I can purchase extensions. Fingers crossed I don't need.. I did call SR, they were helpful in a sense they gave...

Just purchased our 1998 330 Sundancer and will be bringing her home this week! Talked to our Golden Lift installer to set our bunks and he needs to know the how deep the V is, or the deadrise degree. I pulled the manual out from SR.com and I can't find it anywhere... Does anyone on this thread...

Had our new dock and 4 post Eagle lift installed 16 months ago. Finally bought the first boat, a 98' 330 Sundancer and bringing her home. Sad part is my installer has been a POS. Dock didn't last and he's disappeared. I've reached out to at least get the width for bunks for the Searay but it...