I don't recall seeing a dish washer option in any of the owner docs. The only option i'm aware of is the trash compactor. I agree you probably want run the drain to washer dryer line. I don't htink the sump would handle the flow.
The cockpit air on our boat will cool the helm down pretty well even with 100 degree temps. I try not to use it on really hot days when we are anchored because it works the compressors pretty hard, they don't really cycle at all they are locked on to keep things cool. However the 510 uses two...
This is in response to te question of smoothness between the diesel DA and the gasser Da. I own both a 1998 400 and a 2002 510. when I take the 400 out for excersise the first thing that hits me is the relative smooth and quiet on the 400. Now I don't know if this is a fair comparison because...
I got a package of plugs from West Marine. They vary in from about half inch to 2 inches. God forbid you ever need them but you'll be able to hammer em in with that big hammer.
That beats my pair @.03473. 660x2/38000lbs. I think the 510 was available with bigger engines than the 3196, but i don't know what the HP ratings were. Maybe Frank will way in.
You know with reference to the sae vs metric question, I bought one those package deals at Costco with metric and sae sockets and wrenches. it was less than 100$. It's got every thing, pliars, screwdriver bits and handle, allens(sae and metric). It's been pretty handy. I have not done much...
You need a good digital volt/ohm meter, and a cordless drill and bits. Also an assortment of electrical connectors. Oh yes one more thing would be an assortment of would plugs. That should get you started.
We have temps well over the century mark, and our salon unit will hold the the temp at 65 deg with no problem. The only time I've and a problem is when the filters get dirty. Are you sure you've cleaned all the filters? I know the DA may be a little easier to cool because we dont have all the...
Jack I used to do it the way Laze Daze describes, when we had a 24ft Bayliner cruiser. It worked pretty well as long as I droped plenty of rode. It does require a little guess work with reference to swing room and how close you are to shore. Weying anchor was a real pain without a windlass. I...
I assume he needs the ESN#. If so that will be found on the sat module connected to the radio. If the head unit is sat ready he will need the seperate tuner module. Hope that helps.