Recent content by Edwin Stigile

Being a new boat owner this forum is a great resource. Thank you all. I believe I have found one of the sources of the rust coloration in the bilge. The water distribution bracket is rusting pretty good on the bottom. Other than that you can see from the images the engine looks in pretty good...

Thank you for the reply. Yes I do see the drain holes from the anchor locker to the ski locker to the bilge area. The manual refers to inspecting limber holes in the bilge area under section 8. It might be that this manual was copied and pasted from an older manual and my model does not have the...

Thank you all for your reply's. I recently purchased the boat so I dont know to much about the previous owner storage habits. I do know he is store it on a lift for at least a year or two which is where I believe the water staining in the bilge is from. Yes the previous owner did replace the...

Hello, I am new to being a boat owner and have noticed some what I think is a mfg defect in fiberglass and some gelcoat chipping in the bilge area. I am hoping you can help me out and let me know what I should do to keep my investment alive. I have read that the gel coat chipping is not a...

Hello I am new to the SeaRay community i have a 2007 Sea Ray 205 Sport. In the manual it talks about inspecting limber holes but does not provide location. Where are these located?? I could not find any images or diagrams online. Also does anyone know if they used wood or composite for this...