Recent content by Edwin G Littke

On my '96 Sundancer 450, I just lost power to the accessory switches and the depth finder switch. Have checked the one fuse I found behind the panel and the breaker in the small breaker panel by the helm station. All ok, anywhere I should be looking? Thanks

The #1 does not get used cause it does not pressurize

The #1 pump does not pressurize so it does not turn off.

My 1996 450 Sundancer has two fresh water pumps. The number 1 pump seemed to have very little pressure, just tiny amount of water would come out, so I replaced it. The new pump still does not pressurize and pump water. The number 2 pump works fine all by itself. Looked for leaks and cannot...

Right, thanks, I will deal with it over the winter. This is the older type. We are in Cape Cod Bay. Pretty clear water. I have pumps under the engine near the seal that pumps to the rear main pumps. The leaking that occurs underway cycles the pump on about every 20-30 minutes. Since my...

Hi I am dealing with a 1996 450 Sundancer with a shaft seal that is streaming water while underway. Likely the original with two more spares on the shaft. Bilge pump cycle on about every 20 minutes running at 16 knots. No drip sitting at the dock. I have a 4 hour trip to my haul out marina...