Looking at a 98’ that has 3196s with Twin Disc EC-100 controller. Anyone have experience with this setup? It is nice in that it allows you to troll at 1 knot or less but it’s definitely old.
05’ 320DA. Any idea what these are and where they lead to? They lead behind the port side lounger and down into the boat behind the medicine cabinet in the head. They look like they could be subwoofer wire that was wired from factory but no subwoofer connected. Any ideas what they are and where...
I removed the connectors, stripped to clean wire, replaced the old connectors and all systems are normal! There was corrosion under the engine bay connector that was probably causing the issue.
Monitor worked and tested out alerts with new coax ran to the module. Should I take the time to see if putting new ends on the old cable works the or just run a new coax?
Finally replaced my systems monitor which was dead when I purchased the boat. Any input on what I could check here? It says SEA RAY BOATS ALL SYSTEMS NORMAL then switches to this screen. I do not see an orange wire anywhere to connect. My stereo is disconnected as I’m redoing it.
I’ve checked and swapped both fuses on the side of the solenoid. I’ve had the boat for a year and have just dealt with holding the helm switch simultaneously with up or down. Now I go to fix it and holding the switch no longer works
2005 320 DA
When I press the helm windlass button the solenoid just clicks, and the windlass will not work when released. HOWEVER, When I hold down the helm button simultaneously with the up or down the windlass works perfectly from the helm and the foot pedals. Any ideas? Bad solenoid or...
6.2L MPI Horizon MPI, V drive
I changed out the large idler pulley as it was making some noise. Reused belt that was in perfect condition. This motor has the manual tension adjustment where you use a 5/8 to secure and 5/16 to turn the pinion stud.
I have the pulley fully maxed out to the top...
So yes, you were 100% right. I was able to get them off by taking needle nose pliers directly in line with the screw and the edge, shoving them as deep as i could get them and pinching some of the fabric to pull it back to access the screw. There is no way to prevent it from tearing from the...
What is the trick to removing this to replace the speakers? I started removing the light, bolts behind the light, the upper bolster and I still could not figure it out. Thanks for the help!
This is the setup I'd like. The problem with the 320 V drive is space for the fuel tank. Pretty sure I need a custom poly tank placed to the stern of the starboard fuel tank.