Recent content by dsarge390

Helen and I had a great time! Good job to everyone involved. Thank you for your hard work.

Ducky is right, be sure you have a manual for the unit. I was able to change some settings that made our unit run better. Such as max blower speed and night backlight on the display. It always seemed to be shining right in my eyes. Our manual was in a carry case under the flip up backrest in...

The AC only runs on shore power or generator. The water will flow only when the Compressor is activated (cycles). It will set a trouble code if there is poor water flow or the refrigerant pressure becomes too high (Lack of flowing water, removing heat from the refrigerant). There is a...

Wayne. I recently had an issue with my radar too. Chances are that the fuse panel is receiving power and ground, due to the fact that other devices usually on the panel are functioning. The Radar power should plug into a fuse panel under the helm. The fuse panel is out of the direct elements...

So, update. The radar connection cable runs from the radar arch, down to the helm, and across the helm to the C90w display. About halfway across the helm, behind the gauge cluster, the cable ends. The Ethernet connection continues to the display uninterrupted. The power and ground cables...

Brunswick is not selling. Didn't think it was "old news", It was announced yesterday.

No more Sundancers!! https://www.palmcoastobserver.com/article/brunswick-corporation-to-shut-down-palm-coast-sea-ray-plant-eliminating-hundreds-of-jobs

Hello, all. My radar stopped working the other day (right before having to run in fog, of course). I have the Raymarine unit on my 2011 Sundancer 350. I believe it's the non-HD Digital unit. The display says "No Data". Doing my research, it appears to be a power issue to the radome. I checked...

Hello, Ron. Give me a call on my cell 908-499-0331 I have all of the bridge times and I can give you some tips. Kevin

I use this works great and no holes.... https://www.seasucker.com/collections/marine/products/3-rod-holder-6-seasucker

All paid up!! Ready to go!

Sorry about the late post, TALON. I was out of town. The hull on the 2011 dancer has speaker "mounts" molded into the transom. I replaced the factory Sony speakers with the JLs. The JL speaker fit right into the opening, but a couple of mounting holes had to be relocated. No big deal. The JL...

I run an all JL system in my 2011 350 Dancer. 400/4 Amp for the cockpit speakers (JL 6.5s) and a 300/1 driving a single 10" sub. I also have the small 200/2 on the two swim platform speakers that are on a separate on/off switched circuit. My wife yells at me because it is LOUD and sounds great...

Sorry about the delay, I was on vacation, and "off the grid". Thank you for the updated slip assignments. See everyone Friday!!

PM me, sean. We have a condo we rent in Ocean City, NJ. Right on the beach. There are several marinas near it that take transient slip renters, or if trailer the boat, lots of launches. It's a beautiful area. We dock our boat at Harbour Cove, Somer's Point, NJ. It's right over the bridge to...