I have a Cruisair heating/air conditioning unit. It's tripping the circuit breaker and the copper pipe I am pointing to in the picture is getting almost too hot to touch. Any ideas on what could be the problem?
Thanks for all the valuable input. I've traced the wiring and have not yet found any corrosion of bad connectors. The one thing I haven't been able to find is the breaker between the motor (the lift is electric, not hydraulic). Anyone know where I should look?
2017 400 Sundancer. Bought brand new in 2018. Never had a problem with the electric swim platform until a couple of months ago, when the fuse (10 amp) started blowing. So far put in a new circuit board ($950) which seemed to help for a few times of using the lift. But then started blowing fuses...
I'm getting a low oil pressure signal on my Cat 3116 starboard engine and it's shutting down my engine. I know it's not the sensor because I swapped the sensor with my port engine and I still got it on the starboard. Also, I know I don't have low oil pressure because I clear the alarm and...
Has anyone who owns an older 400 Sundancer had problems with the carpet in the aft cabin getting wet/stained? I've had this problem for a while, and can not figure our where the moisture is coming from. I was just wondering if anyone else had experienced this and be able to trace where it's...
Well it's not the duckbills :(
Replaced the 4 duckbills and re-installed the vacu-flush. Nothing's changed, bowl holds water, and pump cycles but never shuts off. I'm getting a vacuum at the bowl, when I flush it I can hear the vacuum/suction.
Any ideas??