Recent content by Don Hardison

I’m looking for a steering wheel for 2002 Sundancer

Since my cabinets were rotted basically. I asked a friend who does cabinets to see what he could do. He also made a grate for the floor to match.

That was the reason I bought it, I'm not off shore much and usually within sight of land. The original had the crumbling microphone cord and I snapped the antenna this weekend at the tip. So I was able to make a white bezel for new radio, connection wasn't that difficult, but was worried about...

Cobra, cord is connected to the antenna and terminated with coaxial connector

replaced the old VHF radio and now working on antenna. Noticed with new antennas, the coax connector is larger than the drilled hole in the side of the boat. Anyone else rerun their antenna wires?

Anyone using a large flag pole set up and how?

if this shows up as a double post my apology in advance. Is there a inline fuse behind the dash that controls the electric keypad (controls for lights, depth finder, blower, sump, horn, etc). Mine went out yesterday. Checked fuse block under dash all fuses there were good.

Is there a master fuse for the switch panel that controls the lights, horn, depth finder, blower, bilges on the helm? My entire panel went out. All the fuses on block are ok, so thinking it's an inline behind panel?

That's is impressive!

Can you share a photo of your project?

replace the rotted out cabinets that house the microwave and cubbies with sliding doors.

Has anyone ever replaced the cabinets above the sink in cuddy?

Not sure. Should have posted that also, 2002 Sundancer, 5.0 260 hp

Not sure sorry shou

drained all the fuel. Replaced the filter so all that fuel was also removed. Will be checking lines today, and pump. Yea diagnosing is difficult now that every boat shop has a two week appointment calendar.