Mine was leaking at end cap too mercruiser part diagram shows bolt then metal cover rubber gasket then o ring but repair book states make sure you put o ring between metal plate and rubber gasket.mine would leak at bolt when first did per diagram going out Sunday hope it stopped.
Found outer ring of smartcraft transducer on my boat was missing about one third. just ordered new one last week from marine max sea ray dealer for$124.98 said it will have plug on it.part number mm2620329 that's for 2005 should be same checked dealer yesterday said part on way said came from...
No alarm beep and no fuel pump energizing and would not turn over. Mine worked after removing plug wires off switch a couple times. second year I had mine port engine would not start almost would but wouldn't searched everything it was the common problem of bad iac valve have pop three in last...
Changed mine last year with lumitec mirage I bought on amazon for $96 each white dimmable,red and blue all you got to do is cut wires and reconnect very happy with them the white can be a lot brighter easier installing canvas at night than original lights.
Back in 1993 When I installed close cooling on a new 5.7 mercruiser with alpha 1 second generation you had to install 2 kits 1 for closed cooling and one with a pump to add on motor pully system for thru hull water said drive pump wouldn't supply enough water to cool heat exchanger. It was a...
Greatlakesboattop.com phone number18778677861 did mine last year The three front they made mine originally. Around $400 also l got new carpet runners $140 everything fit perfect but you have to install snaps they come with them so buy tool. Took two hours easy to do.
I also have wood grain and new one came in black. Just cut out small Philip head screws and change over to wood grain panel and reseal new one that's what I did. Got small pointy knife at Home Depot and small tube of clear silicone.
Same problem all last season on my port side buttons that control blower,bilge pump and accessories sometimes would work sometimes all little green lights would flash and not work. if I hold bildge button it would clear and work normally sometimes. Drove me crazy. Replaced with new switch pad...